If it were mine, I would have someone get inside of the trunk(boot)with a flashlight. Close it and then run some water over and around the edge of the trunk; not too much pressure. Start at the bottom(closest to you) and slowly work your way around one side to the other and then back to the bottom. In other words, make a loop around the edge of the trunk. Your helper should be able to see where the water is coming in, if there is no leak then it might be around the taillights or rear window. If the leak is around the trunk weatherstrip, either replace it or close the gap at the leak by hammering the lip of the trunk opening, not the trunk lid itself. If it around the taillights or window, try using some silicone sealer.
You can use an oil stop-leak product to stop an oil leak on your 2002 Peugeot 206 1.4.
If you have an engine oil leak on your 2002 Peugeot 206 1.4, you can use an oil stop-leak product to fix it.
Repair the pipe of fixture to stop your leak.
Repairing the section of pipe that is leaking will stop a leak on a hot water line.
The stop warning light can mean your car is over heating even tho your temp gage is siting at normal or there's a leak at the water pump. This happened to me and took £5 for a seal
You can put a new or rebuilt water pump in to stop the leak. That's the only right way.
Stop the leak, bail out the unnecessary water, and carry on.
No, it is not intended for that and performs poorly.
Press on the zero of the 607 motive on the boot lid- IF IT DIDN'T OPEN ,THEN YOU WILL SYNCHRONIZE YOUR KEY REMOTE. start the engine,press the lock on remote for 10seconds,stop the engine,wait for another 10seconds.press open for 5seconds.Then try open your boot with your remote.this should work.
A roof leak will only be around when it's raining and a plumbing wall leak will be there forever. Which do you have? Food coloring in water and poured down suspected leak paths is very useful. Use different colors.
No. they're dissolved in each other and are quite hard to seperate.
How many miles did you operate the vehicle between the STOP LEAK instalation and and the stalling problem? Where was the bad leak?