I assume that the tappets have been adjusted and are still tapping. Then what you need to do is to remove the rocker cover you will then see the rocker shaft held down by four bolts, undo these bolts evenly so as not to distort the shaft, turn the rocker assembly over and you will no doubt find, that the pads, which press onto the valves are indented, you will need to reface the pads with an oil stone following the existing radius of the pad. After this thoroughly clean the rockers and shaft before refitting. Ensure that the rockers are lubricated and properly located onto the push rods thenre tighten the bolts progressively, readjust tappets, refit rocker cover.
Not all mk4 fiesta 1.3 have pas.
mk4
It does not have one. The mk4 fiesa has a hydraulic clutch.
Yes,the mk4 and 5 chassis' are identical and generally any fiesta front wheel drivetrain can be transplanted into any other fiesta engine bay up to mk6.
Whats wrong with it?
No, the floor pans are completely different. The MK3.5 will fit the MK4.
did you ever figure out if you can do this as i want to do the same
just about everything
SACH clutch is probably the best.
4.5"
Yes no problems at all as the mk4 and 5 are basicly the same car.
5 1/4 inch, or 13cm