There are a couple of ways to remove paint from furniture, but the easiest and less time consuming is paint stripper/ remover. Just remember to wear latex gloves and eye protection. If these products can dissolve paint just think what they could do to your eyes and skin.
Here is how I strip paint, varnish, polyurethane or nearly anything else from wood surfaces. First, go to your local home store and pick up the following items you will need for stripping paint from furniture.
1. A can of paint stripper. Look, or ask for the gel type of stripper. It tends to stick to the furniture much better than the liquid type.
2. You will need lots and lots of rags so just buy one of the small bags or boxes your home store carries.
3. A stiff plastic putty knife approximately 2 inches wide for scraping the stipper off.
4. A small disposable paint brush for spreading the stripper.
Be sure to give yourself plenty of space for working on your project with a lot of newspapers underneath to catch the excess stripper.
The biggest mistake people make when stripping furniture is not giving the stripper enough time to work effectively. After you apply a good, heavy coat of paint stripper leave the project alone for at least 30 minutes. You'll know if the right amount of time has passed because to paint will come right off. If not, and because you lost patience, then it can become a nightmare.
Two basic things to remember: patients and lots of stripper.
This will be a LOT of work, since you will have to COMPLETELY strip the floor of its finish first. Then you can use floor paint on it, assuming this is in a protected indoor area.
I would recommend a good wax stripper product such as tsp to strip wax on any floor
infared paint stripper
I'm taking a guess that it is Latex Paint. The best and fastest way would be to use a Paint Scraper. Stripper would work but it would take the Final Finish off of your floor. If it is a large area, you could use a Heat Gun...carefully as that also would take the Clear protecting coat off of the floor. I would go with the paint scraper. Not a Putty Knife, a Paint Scraper.
First prime it with a concrete floor primer, available in Home Depot about $25 per gallon. - You will use much less finish paint this way.
With a tin of paint and a brush or roller. First, be sure all of the old finish has been removed. Then prime and paint with paint specifically prepared for floors. Please note that painting a hard wood floor usually decreases the value of the property. Consider refinishing instead. Older floors were made with fairly thick boards, so they can hold up to several strippings and refinishings.
There is a product called Goof that does a pretty good job. Assuming the paint is fresh, if you are quick about cleaning the Goof off, it shouldn't lift the finish on the floor. Depending on the finish on the floor and how long the paint has been there, you might be able to scrape or peel it off with a fingernail.
Oil based paint is best removed with mineral oil or heavy cream like a cold cream. Do not use paint thinner on your skin, it is way too harsh. For latex paint, use soap and water, if the paint is dried use hand cream of baby oil.
hard wood it is way cheeper but way worse
Best way to clean hardwood floors is with a damp mop. Before mopping, make sure that you have removed all surface dust from the floor. To remove wax you should consider buffing out old wax and resurfacing the floor. Heat and scrape. I would recommend being careful. Damaging your hardwood floor could cost a lot of money to repair in the long run
Removing dirt, dust or sand from the floor. Sweep the floor properly with a broom which has soft bristles. After that use one soft dry cloth to clean it. mngranite.co
One great way to clean a hardwood floor is sweeping it and vacuuming it every day. Then, every week or so, you should use one of the sweeper mops with the spray like the swiffer jet.
if you knock it for good luck and your luck goes your way
Buy a hardwood cleaner kit. It's an alcohol based cleaner you use with a soft terry cloth. After vacuuming or sweeping, spray on and immediately wipe clean.Never use a steam mop, regardless of the claims of the product, and never use Murphy's Oil Soap since it is mostly vegetable oil and will cause the floor to look dull and will eventually damage it.The best way to clean hardwood floors is with a damp mop. Before mopping, make sure that you have removed all surface dust from the floor. This can be done with a soft broom or lightweight vacuum cleaner. Then, simply mop, rinse and repeat. It is important to remove grit and dirt from hardwood floors. Dirt and grit are the biggest enemies when it comes to scratching or scouring the floor finish.
It's not always necessary to use hardwood floor cleaner on hardwood floors. While dedicated hardwood floor cleaners are designed to be gentle and effective, you can also maintain your floors using a damp mop with water and a mild pH-balanced soap. Avoid using excessive water or harsh chemicals, as they can damage the wood. Regular sweeping or vacuuming to remove dirt and debris is also crucial in preserving the beauty and longevity of hardwood floors. However, for specific stains or deep cleaning, a hardwood floor cleaner can be a helpful option, but it's not always mandatory for routine maintenance.
the best ways to remove scratches from a hardwood floors are either you sand it or have someone do it for you
I have done this and I always have the hardwood installed first. Then I install the ceramic tile. To protect the hardwood floor from getting grout or glue on it I cover the hardwood floor with a soft cover (to prevent scratches) and tape it down. Then place a plastic cover over the hardwood. Then I can install the ceramic tile at the edge of the hardwood creating hardly or no seem and level with the hardwood. When its done it looks beautiful.I would install the tile first , that way you don't risk getting glue or grout on your hardwood.
no I have seen it done (really), but it's a bad idea.
The quickest and most effective way to clean hardwood floors is with a damp mop. Before mopping, make sure that you have removed all surface dust from the floor. This can be done with a soft broom or lightweight vacuum cleaner. Then, simply mop, rinse and repeat. It is important to remove grit and dirt from hardwood floors. Dirt and grit are the biggest enemies when it comes to scratching or scouring the floor finish.
I'm taking a guess that it is Latex Paint. The best and fastest way would be to use a Paint Scraper. Stripper would work but it would take the Final Finish off of your floor. If it is a large area, you could use a Heat Gun...carefully as that also would take the Clear protecting coat off of the floor. I would go with the paint scraper. Not a Putty Knife, a Paint Scraper.