Want this question answered?
You may not have your Dish satellite receiver on the correct channel if it is a duo (dual receiver). You will need to tune it to either 60 or channel 73. Also, make sure your power to your Dish Network receiver is on -- for the Dish TV duo receiver, you should see a light for TV2 and TV1.
With a DISH Network receiver this is definitely possible, it is referred to as a "Dual-Tuner," and as long as the receiver is in Duo Mode, it allows you to watch independent programming on both TV1 & TV2. So the answer to your question is Yes, you can operate two TVs off of one DISH Network satellite receiver. Hope this helps you out!-Kirstie DISH Network
Dish Network satellite receivers upgrade automatically, usually at night depending on your settings. You can encourage a software update by making sure the receiver is in "stand by" mode. If you have a Dish TV duo receiver, you must make sure both TV1 and TV2 are off. Wait a few minutes, if a software update is available you will see the message that your receiver is updating. If not, call Dish Network customer service.
siaran langsung bola sepak tv1
Research has shown that there are a number of different options for TV1 and each one is in a different country. There is a TV1 in Malaysia, one in Australia and one in Italy. These are just a few of the TV1 options that were found.
Check the TV1 schedule online for Forrest Gump showings.
Below are the steps to program a remote to your second TV. Addressing Remote to Receiver: 1.) Take your TV2 remote to your TV1. 2.) Go to System Info screen from the TV1. 3.) Hold down the SAT button on your TV2 remote until all mode lights light up. 3.) Enter a number between 1 and 15 using the numeric keypad on the remote. 4.) Press the pound (#) button. 5.) Once the SAT button blinks three times, press record. 6.) Test remote and see if it works.
The channel a TV needs to be on isn't based upon the brand of TV. The channel you need to use depends if it is for TV1 or TV2, and what cable is being used. Using a Coaxial cable on TV1, you will want it to be on Ch. 3 or Ch. 4. For TV2, you'll want it to be on Ch. 60 or 73. The channel number may vary with each TV, but it isn't model specific. If you're using an input cable, such as an RCA cable or an HDMI cable, all you have to do is change the input on the TV to the one matching where the cable is plugged in.
Below are the steps to program a remote to your second TV. Addressing Remote to Receiver: 1.) Take your TV2 remote to your TV1. 2.) Go to System Info screen from the TV1. 3.) Hold down the SAT button on your TV2 remote until all mode lights light up. 3.) Enter a number between 1 and 15 using the numeric keypad on the remote. 4.) Press the pound (#) button. 5.) Once the SAT button blinks three times, press record. 6.) Test remote and see if it works.
Some of the more popular shows on the TV1 channel in Australia are Killing Time, CSI, House Law & Order, Monk, 30 Rock, and The Office. TV1 is a cable and satellite channel.
Discovery Channel have an on line shop where a 4 DVD set is available for about 35 dollars http://store.discovery.com/?v=discovery_dvds-books&ecid=PRF-TV1-100001&pa=PRF-TV1-100001
If you want to record always to TV 1, you can set the recording preference to TV 1. Press the Menu button on your remote. This will display the Main Menu on your TV. Press 8 (Preferences) and 5 (Record Plus). For Activation, set to Enable. For Record Preference, set to TV 1. Select Done, Cancel, and Cancel to get back to your TV screen. Now, any time you setup a recording it will record to TV 1.