Below the black handle is a silver ring, you need to loosen that all the way and then twist of knob handle.
shifter rod gear linkage
The nylon bushing at the bottom of the shifter is worn out. remove console. put shifter in the neutral position, unbolt shifter from transmission. replace bushing, then reinstall. good luck...
An Ocean Apart - 2004 was released on: USA: 15 October 2004
If you look at the drivers side of the transmission were the shifter linkage hooks to it you will see an electrical switch behind it. That switch controlls the backup lights among other things.
If you look at the drivers side of the transmission where the shifter cable hooks to it you will see an electric switch behind the cable where it hooks to the transmission. That is it.
Where is the oil filter in a 2004 Chevy Malibu
what size speakers are in the 2004 Chevy Avalanche
Where is the thermostat located in a 2004 Chevy SSR
I have a 2004 blazer and my manual shifter is removed by turning the hex nut just below the actual shifter clockwise. This may sound counter-intuitive as that is the direction to tighten but this spins the nut away from the shifter so the shifter is free to spin (counter-clockwise). So.... 1. Push boot around shifter down toward floorboard to expose shaft/nut coming out of tranny/gearbox 2. Turn nut clockwise to get away from shifter ( i used a small crescent ) i used a combo of 1st gear and reverse to get the right angles to fit wrench in. 3. Turn by hand the shifter (counter-clockwise) to remove. Or use pipe wrench with cloth around shifter to start the motion if stuck. Use a thick cloth to not scratch paint. 4. Nut and shifter are both free now. 5. This is also how you adjust the height of your shifter if you wish. Hope this helps
80,566 2004 Chevy Avalanches were produced
2004 chevy mailibu starter location
How do you change the front rotors on a 2004 Chevy tracker