If it is a 4.0, loosen the two rear steering pump mounting bolts, the upper pivot bolt, and the locknut and the adjusting bolt located on the bottom of the unit. Push the steering unit in and remove the old belt. Remember how it was routed. Replace with the new belt. Pull the steering pump back and tighten the adjusting bolt for tension. Then tighten the other bolts.
ATF +4 for an automatic.
Should have an automatic belt tensioner - if tension not correct replace tensioner
he serpentine, or accessory belt.
The correct factory tire size for a 1994 Jeep Wrangler is 215/75R15.
Yes, it will fit just fine.
Certainly, they are both YJ"s.
It is a 42RLE.
serpentine belt loose
my jeep wrangler is starting to have a hard time to start in the mornings? my jeep wrangler is starting to have a hard time to start in the mornings?
A ratchet isÊneeded to loosen the serpentine belt tension pulley on a 2002 Jeep Wrangler V6. It will require a 1/2 inch ratchet.
automatic with 6cylinder motor
Al YJ's are compatible, 89-95
A 1994 Jeep Wrangler needs approximately 6 quarts of oil for an oil change.
I need a routing diagram for the serpentine belt on a 1998 Jeep Wranger, 4 cylinder, with air conditioning
it will fit no problem
It does no have one.