you only need to remove one screw, which is behind a small screw cover located in the inside door handle. pop open the cover with a small screwdriver, then remove the screw with a Phillips screwdriver. Then pull the panel out from underneath. There are about 5 plastic clips holding the panel in place at the bottom. look for the spot with the most gap and pull straight out and move along the bottom until all the clips are popped out. Then carefully raise the door panel, which hooks down on the door frame at the top where the panel meets the glass. At the same time you raise the door panel, slide the inside door handle unit to the left (if working on the driver side door) which is toward the pointy end of the door handle unit. This releases the unit from the door panel. Once you slide the this unit all the way you'll see that it's held in place by two clips. Then carefully push this unit through the hole on the door panel to separate the panel from the door handle unit. Once the panel is separated from the door framd, remove the two electrical clips that power the power windows and mirrors. It takes some coordination, but that's how the panel is removed.
This allows you to work on replacing the door window glass, repair broken exerior door handles, and tighten the side mirrors.
screws on the inside of the door, almost on bottom
Take the whole door panel off. The grill will come with the door panel.
Removing a door panel from a 1995 Ford Contour is very easy to do. You will need to take the speaker casing off by taking out the two screws. Then you will need to take the clips off that are holding the door panel in place. There will also be two retaining screws to be taken off the door panel with a Phillips screwdriver. After all the screws and clips are off, the door panel can be lifted off.
On a 1995 Chevrolet Caprice your door panel and window switch are two different parts. To remove the door panel you remove the 8 screws along the outer edge of the door and then pull the panel off. to take the switch off there are 4 more screws on the back of the panel you remove
take the door apart then put it back on that's what i did to my metallic blue 2000 Honda civic with yellow flames on the side
take door panel off 1995 gmc truck.
Remove the screws under the door handle on the door panel, and take off the trim plate. Then remove the door lock knob by untwisting it. Pull the door panel with a putty knife or door panel puller, removing any screws and disconnecting the wiring. Take speaker out by removing screws that should now be visible.
Take off all the screws on the door panel.
I found this excellent website with the information... I hope it helps... http://www.bodyshopzone.com/archives/trim/door_panels/Honda/Ridgeline_2007/remove_dp_07_Ridgeline.html
Remove window handle(pin removal tool 5.95 advance auto), take screw out of door handle, take 3 screws off speaker cover, remove 3 screws holding speaker in, unplug speaker, pop 4 plastic snaps loose from bottom of door panel by sliding a screwdriver between panel and door. Then slide panel upward and lift it off.
You must first take the door panel off, you will see screws by the handles where you pull the door closed and where you open the door. You then must pop off the door panel but be careful not to brake the plastic locks that hold the door to the metal pull easily. Once off you can take out the speakers.
there are hidden screw all over. Take off and look behind all the little panel around the door handle, the power window botton and I think there might be a couple more