answersLogoWhite
Head Gaskets and Valve Covers
Nissan 240SX
Air Filters and Intake Manifolds
Ford F-250

How do you take off the intake manifold of a 1990 Nissan 240SX KA24E to replace the head gasket?

323334

Top Answer
User Avatar
Wiki User
2005-12-28 19:59:15
2005-12-28 19:59:15

you have to take the throttle body support bracket loose. it is under the bottom mounted to the engine. you cannot remove it otherwise. I know as i did the same.

1

Related Questions

User Avatar

Yes, you must install a new intake manifold gasket.

User Avatar

Replace gasket why does gasket keep sliding

User Avatar

The only fix for a bad intake gasket is to remove the intake manifold and replace the gasket.

User Avatar

No. which manifold gasket are you wanting to replace? Intake or exhaust?

User Avatar

Remove the intake manifold retaining bolts from your 1996 Chevy Astro Van. Remove the manifold gasket and clean the surface. Reverse the process to install the new intake manifold gasket.

User Avatar

Pretty straight forward. You must remove the intake manifold in order to replace the gasket.

User Avatar

the knock sensor is located under the intake manifold, with a flash light you can see it however you have to remove the intake manifold to replace the knock sensor , also you will need to replace the intake gasket set as well!

User Avatar

there is no lower intake gasket, only a front and rear gasket

User Avatar

The labor charge to replace and intake manifold gasket, on a 1999 Chevrolet Tahoe, is approximately $180. It takes approximately 2 1/2 hours to replace the gasket.

User Avatar

Yes, you need to replace your intake gaskets.

User Avatar

how to replace a distributor gasket on a 2000 Pontiac grand am 3.4l

User Avatar

The intake gasket is the gasket that conncects from your air filter into your intake manifold

User Avatar

Remove everything on top of the intake (hoses, fuel rails, linkages.) Unbolt the manifold and remove it. Clean the old gasket off and replace it. Reinstall all parts removed to get to the gasket.

User Avatar

Your intake manifold gasket needs to be replaced.

User Avatar

I just had the intake manifold gasket replaced on my 96 century yesterday and my bill was $450 but my gasket was only leaking out. If its leaking into your oil it may be more.

User Avatar

The knock sensor for most Nissan V6 engines is located directly under the intake manifold. So to replace it, you have to remove the intake manifold. Good Luck.

User Avatar

between the head and intake manifold

User Avatar

Between the intake manifold and the cylinder head.

User Avatar

Yes, remove the intake manifold and replace the gasket. It can be done with a basic mechanics tool kit.

User Avatar

Assuming this is a 4.3L engine, the upper intake manifold gasket would be between the upper intake manifold and the lower intake manifold.

User Avatar

remove the intake and exhaust manifolds. there are bolts that attach them onto the head and there are bolts near the carburetor that attach the intake manifold to the exhaust manifold.

User Avatar

It should take about an hour to change the intake manifold gasket. This part can be replaced by taking off the intake manifold cover, cleaning the old gasket off and sealing a new gasket in the space and tightening the bolts. When other things are in the way, like the alternator, it will take longer.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.