Want this question answered?
in side the truck fold back both sides of the carpet take off the nuts on both sides then take out the rear tail lights and un fasen the top of the bumper there are plastic clips under the car that snaps to the rear bumper then finnaly take off the screws right behind the rear wheel note leave a couple of screws in the top so the bumper cover does not fall off ggood luck racer buck3
in side the truck fold back both sides of the carpet take off the nuts on both sides then take out the rear tail lights and un fasen the top of the bumper there are plastic clips under the car that snaps to the rear bumper then finnaly take off the screws right behind the rear wheel note leave a couple of screws in the top so the bumper cover does not fall off ggood luck racer buck3
you take it to a mechanic
There are only 2 bolts holding it on, take them out with a 3/4 wrench and wiggle the bumper off.
200 Newtons
It's held on with push pins.
You have to take out the bumper. Just take out the screws that are in the fender, take out the plastic cover that it is under the car that is attached to the bumper, take out the clips of the plastic grille with the Honda logo and pull the bumper. Don't apply to much force. When the bumper is out you will see the other bolts to remove the headlight.
To remove the headlight housings on a 2003 350z first take the bumper off the car. Remove the wheel well covers to access the rear of the lights. Locate the four mounting bolts of the headlights and loosen them. Unplug and remove the housings.
yes
This is how to take the entire rear bumper assembly off, not just the visible steel bumper. Looking under the jeep from the rear, you'll see two "arms" or brackets that go from the inside of the bumper to the frame. There are readily accessible bolts that hold those brackets onto the frame. Undo them, and its off. Be sure to have help holding it up or brace it so that it will not fall on you when you disconnect it. They weigh about thirty pounds or so.
Take the old one off, and install the new one. Dick.
- Remove 3 screws in each rear wheel well (6 total). To get to bottom screw, take off wheel or lift car and use stubby screwdriver. - Remove 2 screws in the rear hatch, 1 on each side. Must have the trunk door open to get to them. - Pull out 4 plastic pins from along the bottom side of the bumper. You can remove the bumper cover without removing the wheels. We used an offset screw driver (shaped like letter "Z"). It can be bought at any hardware store.