Want this question answered?
take bolts out at front left and right side then slide entire seat forward and lift off
Under the tail of the quad on the left side there's a release lever. Pull it and seat will loosen then take it off
two bolt under the front seat left side and right side. they will be a metric Allen head
The Yamaha 1200 motorcycle seat is held in place by four retaining bolts. Remove the retaining bolts and the seat will come off.
Remove seat take left side plastic off and bingo there ya go
Under the seat accessible on the right side after you take off the cover. (by simply pulling with your fingers.)
Look at the ignition key. You remove the seat by turning the key without pushing down on the key to the seat removal location. It says where to turn it to. The seat should then pop up a little in the front.
Remove a bolt (hex) from either side at the bottom of the seat. Near the shock.
there should be two bolts behind the passenger seat, take those out. pull the strap on the passenger seat forward and pull the seat back. after you take the passenger seat off you can see the bolts for the front seat, take them off and back the seat out of the lip.
20 - 21.5mm off the seat of the bowl gasket to the top of the float
the oil that is usually for grizzly is 10w30 but to make sure take your seat off and read the label on your breather it shold be listed under liquids
Been trying to figure this one out too. Under the left rear fender, directly above the tire - find a lever with a red rubber coating. Pull the lever toward the rear of the bike. This will release the latch on the seat. Lift it off from the rear. Good luck!