if you reach under the bottom seat cushion in the center of both seats theres a ring just pull both of them and it will pop out
First you have to take the side panel where the seat belt is and lift up the whole piece will come out
To install interiors rear seat covers for a PUI is not easy. You have will have to take them to a shop to have them installed.
Take the back seat out. Take the front seat out. Take the cover to the battery out.
you have to remove the seat to gain access to the battery. shouldn't take around 30 minutes to take out the old and put in the new. start by removing the rear seat screw on the rear fender, then remove one nut on the grab strap across the seat and you are ready to remove the seat by grasping the rear of the seat and pulling rearward as the front of the seat is in a slot.
No not to replace the fuel pump. It is under the rear seat access door. Then you take a wooden dowel and turn the locking ring counterclockwise.
The fuel filter and fuel pump for a 3g Eclipse is located under the rear seat. You should see a panel near the center. Make sure you take the gas cap off first before you open it as to relieve pressure from the tank otherwise you'll.....well you can imagine the outcome. The pump and the filter is connected to the pump assembly and its kind of a pain to remove the pump. Good Luck!
You can't really, but you can take them out. Instructions are in this website: http://www.ehow.com/how_7636266_ford-contour-rear-seat-removal.html
Remove the Phillips screw or thumbscrew at the back of the seat, lift the rear of the seat slightly and pull it towards the rear tire. It should come right off.
Between the rear seat and the trunk. It is actually behind the rear seat, you have to take out the bottom seat first then the backing, it is encased their. Total time to do it yourself, should take around 2 hours.
In mirage it is usually located under the rear seat just take the bottom part or the rear seat off
take the bolts out
unscrew bolts and take out.