Want this question answered?
Take it to an alignment specialist and have it done, you can't do this at home and get it set right.
The bottom section comes out a little bit easier than the "back" section. Along the floorwall section there is a metal loop that fits into metal bracket under the seat. You will need to pull up on the back of the seat and then push down on the front. You will then be able to take the seat out of the car. The back section also has a similar bracket near the center of the upper back support. You will need to unscrew 4(?) metal screws in the framework of the back support and then lift the section out.
pull the seat base out and then you will see 2 bolts that hold the seat back down to the floor, take the bolts out and the back will come out.
there should be two bolts behind the passenger seat, take those out. pull the strap on the passenger seat forward and pull the seat back. after you take the passenger seat off you can see the bolts for the front seat, take them off and back the seat out of the lip.
Take out the bench seat, and remove the back, take a look. Holes are small.
Yes! It will take about two weeks to regrow back.
very carefully
underneath the back of the seat there are 2 crews undo them then take off the seat
it is under the back seat you need to take off the back seat
Take the back seat out. Take the front seat out. Take the cover to the battery out.
The parody goes like this Sitting in the front seat, sitting, in the back seat, "Get the f**k over here" got to make my mind up which seat can I take
their are 2 clips that hold the seat in so what you do is to get behind the driver seat and push the back seat far back as you can and then pull up and repet on the passenger side