the back seat holds three but seperates into two seats
yes 2000 seats
About 450 dollars at the front seats. About 300 dollars in back seats. I suggest you take the back seats
you take the front seats out and then you put the back seats in correctly
i found out how to do it.
Take Back was created on 2000-12-06.
i have the same issue. i need to take the back seats out so i can put my fusion 6x9" in the parcel tray. I have only been able to remove the bottom of the back seats which come out first but not the back rests of the seats which should come out after the bottom has been taken out. There are two clips underneath the back seat at the front. (One clip for each seat). You only have to unclip them and you will be able to take out the bottom of the seats. Hope this helps ya
how exactly is the seat malfunctioning? no matter what, if you vehicle is an se model without power seats, the seats come out with just four bolts and the mechanisms are very simple and easy to take apart and put back together. whats wrong should be obvious. if it does have power seats you are looking at a much bigger project.
How can I take apart the back of the rear seats in an 2010 rx350? I need to clean underneath. Soup spilled all over.
There are bolts that you must remove in order to take out the front seats of a 2002 Monte Carlo. There are two in the back of the seat and two in the front of the seat. If you have heated seats you will also have to remove the wires for that before you take the seat out.
I have a 95 eclipse gs and mine is located under the back seats in thhe back. All you have to do is take out the bottom part of the seats and there is like a little latch on the passengers side.
you have to cut a hole in the back above your seats that's the only way the screwed them in from the top
there should be a little button on the top of the seats where the headrests latch in, press that button and then pull up on the headrest, it should come off