i have the same issue. i need to take the back seats out so i can put my fusion 6x9" in the parcel tray. I have only been able to remove the bottom of the back seats which come out first but not the back rests of the seats which should come out after the bottom has been taken out. There are two clips underneath the back seat at the front. (One clip for each seat). You only have to unclip them and you will be able to take out the bottom of the seats. Hope this helps ya
Possibly, remove the back seat and see for yourself.
How do you remove the rear seat on a 2002 diamante
its under the back seat. you need to remove the back seat to access it and you'll need a Philips screwdriver and a REALLY tight grip or a hammer to remove it.
To remove the front seat covers in a 2008 Mitsubishi Lancer ES, first, slide the seat all the way forward and locate the bolts at the rear of the seat base. Use a socket wrench to remove these bolts, then slide the seat back and remove the front bolts. Once the seat is free, disconnect any electrical connectors if your seats have power features. Finally, carefully pull off the seat cover, starting from the bottom and working your way up.
there are two clips along with bottom part of the back seat....pull it out and release it. and then you will find there are two screw on both sides next to the seat belt clip. unscrew them and push the seat up.....job done!!
there are two bolts in the back of the seat. remove them and then slide the seat back about an inch and remove
how to remove 2004 scion back seat
The fuel pump is located inside the gas tank remove back seat to find access panel
Triton Ute
To remove the back seat of a Skylark, reach into the area between the back and the seat and pull up on the seat. The back part of the seat is bolted in and will require a socket wrench to remove.
well the first thing is to remove the lower seat. It has two clips near the front of it . Remove the lower seat now. Next remove the side panel right above the back seat. Now you have to remove the bolts for the seat belts, it holds the back part of the seat in. move the back part of the seat up towards the back window. You should hear the seat come loose. Now when you put the seat back in don't forget to pull the seat belts back though.
To remove the back seat of a 1998 Toyota Corolla, you will need to remove the carpet to expose the bolts for the seat. Then, loosen the bolts by removing the nuts. You can then remove the seat.