Note:The drivebelt routing decal on the radiator shroud to help during drivebelt install * To replace the belt rotate the tensioner pulley clockwise to release belt tension * Remove the belt from the auxiliary components and slowly release the tensioner * Route the new belt over the various pulleys again rotating the tensioner to allow the belt to be installed then release the belt tensioner
what parts do i have to take off, to take off the oil pan on a 2003 chevy cavalier
A135
IT IS ON THE FAN SHROUD> If it isn't there draw one before you take the belt off. If the belt is off, go to a used car lot and find a like car and draw a schematic.
Drain the radiator on the 1988 Cavalier. Take of the water pump belt. If the fan and shroud are in the way then remove them. unbolt and remove the pump. Bolt up the new pump and put the belt back on. Put the shroud and fan on if they were removed. Fill the radiator back up.
Take it to a repair shop.
4.5
Use a 15 mm wrech on the idler drum and push down as if you are tightening the bolt. The whole unit will rotate down and take the tension off the belt. Best to have two people for this job
how do you take apart the dash cover on my 2003 Chevy cavalier
you will have to take your dash apart from were the gauges are all the way to the radio
Take of te passenger tire and the shrouding that is there. The tensioner is on the other side of the shroud release the tension from the belt remove the belt. the alternator has two or three bolts holding it in place remove the and the wire from the alternator plus the plugs.
Take it to the dealer.
1988 chevy cavalier flasher take ash tray and bracket out look up and lift you can see it if not you can put your hand up in to lift and find it.