Mercury Cougar
Ford F-250
Ford F-350

How do you take the head light dome light switch off on a 1993 Mercury Cougar?

626364

Top Answer
User Avatar
Wiki User
2015-07-16 19:24:44
2015-07-16 19:24:44

You don't. The switch is all one , you will have to replace the entire switch.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

how do you change a water pump on 1993 Mercury Cougar

User Avatar

A 1993 Mercury Cougar takes ( DOT 3 brake fliud )

User Avatar

What type of freon does a 1993 cougar use

User Avatar

The 1993 Mercury Sable backup light relay switch can be found beneath the drivers side dashboard. The backup light relay switch will be above the accelerator pedal.

User Avatar

You will probably find it is a mercury switch in the wiring bundle.

User Avatar

.040 ========================================================== According to one of Fords websites : For a 1993 Mercury Cougar : The 3.8 liter V6 engine and the 5.0 , V8 have spark plugs gapped at : ( .054 inch )

User Avatar

on the bottom of the rad on the passenger side

User Avatar

where the upper rad hose meets the engine

User Avatar

Follow the positive cable wire from the battery and it will end up plugged right into the safety switch.

User Avatar

To remove the door panel on a 1993 Mercury Cougar XR7, the first thing to do is to remove the lens covers from any lights in the door. The unscrew the light fixtures from the door. The door panel is attached by the use of clips. With a little nudging with a flat object, such as a screw driver, the clips will pop free of the metal.

User Avatar

Either your gas tank is at or near empty , your oil pressure is too low , or your engine coolant temperature is too high

User Avatar

The 1993 Mazda. reverse light switch is located below the shifter column. The relay switch can be seen by removing the center console.

User Avatar

Remove the tire and wheel from your 1993 Mercury Cougar. Remove the ball joint retaining nut. Pound the ball joint out with a hammer. Reverse the process to install your new ball joint.

User Avatar

The brake light switch is located above the brake pedal on a 1993 Nissan Sentra. To reach the switch the driver's door needs to be opened.

User Avatar

There isn't a switch to reset the light. You 'reset' the light by fixing the problem which is causing the light.

User Avatar

Just like all automatic transmission cars, remove the oil pan.

User Avatar

Left of stearing wheel, under the dash (get ready for some strange angles!).


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.