answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How do you take the heater hose off a 2000 demante 3.5?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you remove the heater hose that connects to the water pump on a 1995 Chevy Suburban?

Cool the heater hose and then gently take it off


Can you bypass the heater core with a longer hose in a 1990 jeep wrangler?

Yes, or take one of the hoses loose at the heater core and take it back to the motor on the other one. Shouldn't need a new hose.


How do you bypass the heater core on a 1994 Firebird?

Take both heater hoses off at the heater and the hose running from the front, attach it to the rear of the engine.


How do you flush heater core on 1994 Oldsmobile Cutlass Supreme?

take the 2 hoses off to the heater core and get a hose and flush out the core through both hose fittings on the firewall.


Replace the heater system hoses for a 99 Toyota Corolla?

take off clamps, take of hose, and take of your mom!


How do you bypass the heater control valve on 68 Buick Electra?

take one end of your heater hose off the heater core and run it back to the intake port.


How do you replace the metal heater hose pipes and fittings on a 1991 Caprice Wagon?

Disconnect the rubber hoses from the heater and the intake. Once the clamp is removed, take a sharp knife and split the rubber ends and peal them off. DO NOT pull on the heater core as you can damage the heater core. Take a hacksaw and cut the band off and replace the heater hose using new clamps.


The heater core is most likely plugged on my 2000 2000 Jeep Wrangler. How do you back flush?

I'm having the same problem with the same model. The heater was working fine until I had a new radiator installed recently. I've been told that crud from the old radiator has probably clogged the heater core. From the engine, remove the hoses going into the fire wall. Turn your ignigtion on but do not crank. Turn the heater to on. Take a garden hose, preferably the cone shaped, twist action kind, and put the tip in the end of one heater hose and turn on the water but not too high because too much pressure could blow a hole in the heater core. The water should break up the debris. Repeat through the other hose.


How long does it take to install a heater core in a 2005 neon?

how long does it take to install a heater core in a 2000 dodge neon


I see the leaking power steering hose. How do you know which power steering hose to ask for on a 2000 Hyundai Elantra?

Remove the hose, and take it with you.


How do you flush a heater core on a 99 ford escort?

The heater core is on the back side of the firewall. It has 2 hoses of 1/2 inch diameter running into it. It is about in the center of the firewall. Take the 2 hoses off the firewall. Get a hose with good pressure and back flush the heater core by running the hose into the side with the long hose on it. If you are not sure which side to do then do it both ways.


Where is your thermostat on a 2000 Mercury Cougar?

follow the raditor hose it will have to bolts look for the bolts take them off and it inside the hose.