answersLogoWhite

0


Best Answer

to release tension on a serpentine belt. the easiest way is to use a 1/2 inch socket set breaker bar

insert square part of bar into square hole on tension pulley mount and move in direction of arrow.once you move it far enuff you can slide blet off at least one pully.then slowly release bar

putting new belt on opposite of taking off,but make sure you route the belt the proper way or you wont get the tension needed to operate

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you take the pressure off of the tensioner on a Ford 250?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you replace the belt tensioner on a 1992 Ford F-250 7.3?

How do i change my Serpentine belt on my 2000 Ford F250 Lariat Ext Cab 4x4 V10?


Will a 1993 Ford F-250 tailgate fit a ford f150?

no. unless you take off the emblem that says its a 250, then it might.


How do you remove rotor on a 1997 Ford 250 diesel?

you take it out


Why does 1982 Ford F-250 surge when running?

FUEL pressure, or possible egr valve malfunction.


Where is belt tensioner located on ford f-250 power stroke?

Looking at the engine, it's on the left side (passenger side) below the air conditioner clutch on a 7.3L.


What is the pressure on a 1997 ford expedition air conditioner low pressure side?

40-45psi on low i would use highside put it on 250


How do you release pressure on fuel line 1996 ford 250 with 7.3?

Crank the engine without pressing accelerator.


Why is your 2001 Ford F-250 7.3Lt diesel flywheel clutch pressure plate going out?

Because it was overused.


Where is the exhaust backpressure sensor located on a 2000 Ford F-250 diesel?

The Exhaust Back Pressure Control Valve Module is located in the front part of the Engine Compartment. It is just ahead of the Fuel Filter assembly, and behind the belt tensioner. It is powered by a three plug connecting wires harness.


1992 Ford F-250 Air Conditioner Low Pressure Port?

standing in front of truck, on left by blower housing


Why would an f 250 1999 ford stall and wont start?

Probably a bad fuel pump. Do a fuel pressure test.


How can I take the Play out of the steering wheel of a Ford F 250?

replace the tie rod ends