The Exhaust Back Pressure Control Valve Module is located in the front part of the Engine Compartment. It is just ahead of the Fuel Filter assembly, and behind the belt tensioner. It is powered by a three plug connecting wires harness.
driver side valve cover area it is in the end of a metal tub comming up from the driver side exhause manifold.
The exhaust back pressure sensor on a 2006 6.0 diesel Ford F3 50 can be located near the exhaust manifold. The sensor is a probe that can be removed by loosening the nut.
Where is the temperature sensor located on a 2004 duramax diesel?
Trouble code P0470 means: Exhaust Backpressure Sensor Circuit Malfunction
Could be a diesel? If not then replace your oxygen sensor on your exhaust. A bad oxygen sensor causes the exhaust smoke to be dark in color.
A Ford diesel diagnostic code P0470 means there is an exhaust pressure sensor malfunction. This may be caused by faulty exhaust back pressure sensor, or pressure sensor is open or shorted.
The oxygen sensor is located on the exhaust manifold and is the only item on the exhaust with wires going to it.
According to my Haynes repair manual - the DPFE sensor monitors upstream ( before ) and downstream ( after ) exhaust backpressure . By calculating the difference between the two pressures , the PCM determines exactly the EGR flow rate at all driving conditions
exhaust manifold
where is the crank sensor located on a 6.0l ford power stroke diesel
Where's it located? O2 sensor is in your exhaust so if uts not in the exhaust thrn no
That is the O2 sensor in the exhaust closest to the engine.