Want this question answered?
Between the window winder and door card there should be a plastic ring about 8mm wide. Push this ring away from the end of the window winder. The windes should now slide off
Begin by removing the inside door panel. Remove the linkage from the window winder. Remove the window winder retaining bolts. The window winder will come off.
With a knife. A sharp one.
remove the tiny C clip from under the winder 1.25 1996 N. don't rip it off like I did.
purchase a 'door trim removal tool' from any auto shop and jam it under the retainer under the winder. this will allow the winder to be slid off its nipple.
there is a spring loaded clip on the inside of the window winder prise it forward with a screwdriver or something flat then unclip the spring the winder should just fall off if you have anymore questions dont hesiate to ask just email me at ; tjeast12@aol.com hope this is helpfull for you : ) there is a spring loaded clip on the inside of the window winder prise it forward with a screwdriver or something flat then unclip the spring the winder should just fall off if you have anymore questions dont hesiate to ask just email me at ; tjeast12@aol.com hope this is helpfull for you : ) there is a spring loaded clip on the inside of the window winder prise it forward with a screwdriver or something flat then unclip the spring the winder should just fall off if you have anymore questions dont hesiate to ask just email me at ; tjeast12@aol.com hope this is helpfull for you : )
There is a really thin horseshoe shaped circlip behind the winder handle . Use a screwdriver to gently lever the winder away from the panel and then use a small thin screwdriver to try and unhook the circlip . A bit awkward but trust me it will come off .
there is a clip behind handly use a rag and run it around the hand and door panel and it will come off
loose connection somewhere-->take to mechanic
Hey just went through the same thing, you have to pull of a little metal clip which is located at the base of the winder, its pretty hard to get of and then back on again, but make sure you don't lose it because you cant put the winder back on without it.
just pull the handle away from the door. Put your fingers all the way round and lever it away. shouldn't take too much but be firm and constant with the pressure, and it will just pop off.
The winder fits onto a splined shaft, with a groove cut into it near the end. The winder handle has a spring clip, like an external circlip, which protrudes into the door card. The handle is simply pushed onto the shaft until the spring clip drops into the groove. To get it off, you need to find a way of pushing the spring clip off the winder handle. Try depressing the door card around the winder and look in to see if you can push the spring clip off, from around the handle shaft, using a screwdriver.