0
if its leaking its bad. theirs only one way it can fail. that's leak. theirs only two part's that can fail. the o ring and the housing. and if one or the other fails it leaks.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How does one tell if the clutch master cylinder is bad in a 1988 Nissan D21?
Look for leaking fluid at the slave or master cylinder.
How do you tell if the slave cylinder is bad?
The shaft seal will leak or not work when the system has been properly bled.
How do you know if the clutch cylinder on a 97 suzuki sidekick is bad and it is not the clutch?
After you have located the clutch slave cylinder, have someone depress the clutch pedal. You should see the piston of the slave cylinder extend somewhat. If it does not, either the slave cylinder is bad, or the master cylinder, or, there is not enough brake fluid in the system for it to operate properly. Check the level in the master cylinder. If the slave cylinder is leaking profusely, it is probably bad.
How do you know if it is the clutch master cylinder or the slave cylinder that has gone bad on an 94 firebird?
clamp the line to the slave cylinder and mash the clutch pedal. if the pedal gets hard to push,the slave is bad. if the clutch pedal goes down slowly with moderate pressure,the master cyl is bad clamp the line going to the slave cylinder. meant to say that in the previous answer
Can a bad slave cylinder cause a vehicle to die when you stop?
If we are talking about a clutch slave cylinder for a standard transmission, yes it could.
Where is The location of slave cylinder in 1984 jeep cj7?
my clutch is not working ..think the slave cylinder is bad ..135 , 000 miles ..
Why would clutch fluid leak out on a 88 Toyota corolla?
Bad clutch slave cylinder or failed soft hose from master to slave cylinder.
Where is the slave cylinder located on a 2000 Chevy S10?
The slave cylinder is inside the trans. If you need to replace it you will have to pull the trans out. Its not that bad, its a afternoon though.
How do you fix a slave cylinder on a 1989 Jeep Wrangler?
if slave cylander is bad, it must be replaced to fix it
1994 Ford Ranger 4.0 4WD How do you tell if the clutch master or slave cylinder is bad?
Slave cylinders will typically leak when they're bad. If you're sucking air (getting air in the lines) or the brakes just don't engage when you press the pedal or if the brake pedal fades to the floor; it's a master cylinder.
How do you determine if the clutch or slave cylinder is bad?
If the problem has been getting worse over time than it is your clutch. If was sudden, then it is your slave cylinder. Also, the slave cylinder will usuall leak fluid when it is bad. If your not sure and nobody else is either, replace the slave first. It is farely cheap and super easy to replace. I hope this helps and good luck!
Clutch on golf does not return?
slave cylinder has gone bad or you are out of hydrolic fluid
