0
How do you tell if the transmission needs to be replaced or if it's the clutch in a 1995 Plymouth Neon?
Wiki User
∙ 17y ago
well if you put the car in any gear and let out the clutch if you rev the engine and it dosent move or moves a little then it's the clutch but if it's a grinding noise and it doesnt move at all i'd say its the transmission my car was grinding and not moving and it was cause the spider gears were all busted and i had to rebuild my transmission
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
How do fix a transmission that is slipping in a 1999 Ford pickup?
if it has a clutch, the clutch needs replaced. if it's an automatic, it needs to be overhauled by a dealership or competent transmission shop.
Why would the clutch pedal of a 1987 Nissan 300ZX non turbo go to the floor and stay there when there was no slippage in the clutch during drive?
Clutch release bearing, if installed in this particular Nissan transmission (I don't know the specifics of this particular transmission), probably needs to be replaced. Clutch release bearing, if installed in this particular Nissan transmission (I don't know the specifics of this particular transmission), probably needs to be replaced.
Why wouldn't a transmission go into reverse but goes into drive just fine?
It means the reverse clutch pack has gone out in your transmission and needs to be rebuilt or replaced.
Why won't the tranny in my 95 grand am do anything?
If it is a manual transmission the clutch needs replaced. If it is an automatic the clutches need replaced. This is providing that you are selecting a gear and it is engaged
Clutch slips when decelerating rav4?
Clutch is either misadjusted or needs to be replaced.
If the gas pedal is hard to press when the car is in drive does that mean the cable from the transmission to the throttle valve needs replacing on my 1998 Plymouth neon?
yes your transmission needs to be replaced do not let stay in there to long or it will blow up in your 1998 neon hurry no time to waste
What has to br done to replace a 99 gp flex plate?
The transmission has to be dropped first. then the torque convert/clutch needs to be removed to gain access to the flex plate, which can then be replaced.
What is the labor time on a 1993 Ford Ranger 4WD clutch change?
The clutch replacement labor time is 6.7 hours. Expect another hour if the flywheel needs to be turned or replaced. It is quite an extensive job because the transmission has to be removed.
Can you adjust the clutch on a 323ci e46?
Depending on your problem it may be a serviceable part, however if your issue has anything to do with you clutch plate or fly wheel then no- it is not adjustable. Most of the major components of your clutch (fly wheel, clutch plate, throwout bearing are serviced when clutch is or needs to be replaced because in order to access these parts you must remove the transmission.
What causes a 1986 Acura Integra RS to not go into the next gear?
if u have a manual transmission ur clutch is going out n u need to change it, if u have a automatic ur transmission is going bad and needs to be replaced
Motorcycle jumps and dies when put in gear even with the clutch pulled in what could be wrong?
Your clutch needs adjusted or replaced.
How do you adjust hydraulic clutch on 92 standard sl?
Hydraulic clutch on that model is not ajustable. You either have a bad clutch slave cylinder, Or the clutch and pressure plate needs replaced.
