0
How do you tell where wires go on a unmarked capacitor for ac compressor?
Wiki User
∙ 9y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is on the model number of a HVAC compressor to tell what size capacitor in needed?
3100y20q800cl
What is it on the compressor tell the size?
compressor 220v refigiretor 90watts
How do you tell a shoe size in a unmarked shoe?
If it fits congratulations, if it doesnt then keep looking.
How do you tell if or compressor I need freon?
the effectiveness of the compressor will be low and the temperature at which the environment is cooled will reduce.
How do you connect copper wires to battery?
i will tell you how if you tell me what this project is called,it uses light bulb, copper wires,holder,6 volt battery.
How can you tell if your being followed by an unmarked police car?
Make three consecutive right turns. If they make those turns with you, you're being followed.
How do you tell if a compressor has gone bad in a 1997 Ford Explorer?
If it's the compressor, the telltale signs are usually pretty obvious. It won't cycle, or you'll hear strange noises coming from the compressor, or it'll smoke.
Is my breda brescia shotgun a magnum how 2 tell?
If it indicates that it will accept a 3 inch shell, it is a magnum. If it is marked 2 3/4 inches, it is not. Unmarked- not.
Pl tell me a good Air-compressor manufacturer in India?
alfa lavel pune
How can you tell the difference between positive and negative wires?
usually, positive wires have a blue rubber coating, whereas negative wires have a red rubber coating.
How do you install a light fixture when the old wiring in the ceiling has 4 unmarked wires?
You need a volt meter to find the two wires that are the supply and likely the other two wires go to the switch. In some older houses it is impossible to tell wire colors because of the older wire insulation. Turn off the power at the main panel for starters. Separate all 4 wires so none are touching. check each possible pair to find out which pair belongs to the switch. Put ohm meter probes across a pair. Have someone operate the switch and see if the ohm meter goes between open and closed. There are only 6 combinations you have to check. You can also trace out wires with a tone generator.
How do you tell the colored wires in a 94 dodge spirit?
You dont
