where is the crankshaft sensor located on a 1993 dodge intrepid
try crank position sensor and cam shaft sensor
1999 dodge intrepid is not starting I change crank and camshaft sensor and it stall will not start what can i do next.
On the passenger side bell housing on the near the transmission.
Disconnect the electrical connector, remove the mounting screw and remove the sensor.
No crank sensor on a 1990, only the pickup plate (cam sensor) in the distributor. how about a 1991?
There definitely is a crank position sensor on a Neon
It is mounted to the passenger side of the transmission bell housing, just behind the engine.
Inside the distributor.
If the crank sensor is not working, the engine will not run.
I have a 340 code replaced the crank sensor 3 times replaced the cam position sensor still did not fix it the Dakota runs fine but when it gets warm it will not start until it cools off.
Try the crank sensor first, then the cam sensor. without these the car will not spark. Most commonly the crank sensor though.