It is mounted to the passenger side of the transmission bell housing, just behind the engine.
On the passenger side bell housing on the near the transmission.
Try the crank sensor first, then the cam sensor. without these the car will not spark. Most commonly the crank sensor though.
It doesn't have a mass airflow sensor.
dodge intrepid
Where can I get a diagram of a 1996 Dodge Intrepid cooling system?
diagram for timing marks on 1996 dodge intrepid 3.5
It is located on the exhaust, maybe a foot or so from the engine. which side?
Which do you mean? African or European Intrepid?
Crank sensor failure. It is located on the front of the engine, points down to the crank pulley.
Cam sensor on 1996 Dodge intrepid 3.5 V6 is on the driver's side on top where the cam gear turns on the front of the engine.. Usually has a 90 deg. connector for the wires.. MUST be air gapped correctly to work proplerly.. DO NOT Bottom the sensor out against the cam gear unless the new sensor has a card board disc glued to the end of the sensor to set the gap... Good luck!
The crank sensor is located on the bell housing of the transmission on passenger side. You will need an Allen wrench.
NO. A crank sensor are cam sensor was not introduced until the year 1996.