0
run into a brick wall at 40 mph
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How do you test a 1998 jetta engine speed sensor?
the vehicle speed sensor is on the tranny it hooks onto your speedometer. the engine speed sensor is on the front of the engine, two different sensors guys.
Where can you test drive a Volkswagen Jetta wagon in Vancouver?
Asking your Volkswagon dealer would be a great start as to where you can test drive a Jetta wagon. In fact, the dealer there might even let you test drive a Jetta wagon there, if he or she has one.
When was Crash Test Dummies created?
Crash Test Dummies was created in 1988.
How do you test a 1999 daewoo nubira oxygen sensor when the car goes for the smog test it says obd2 fail?
obd2 means on board diagnostics failed not o2 sensor, 1st have to figure out why obd2 failed.
Where can one see car crash dummy tests?
Car crash videos of crash test dummies are available to watch on YouTube. The crash test dummy has been used for 43 years as a means to safely test car crash results.
When was Crash Test Dude created?
Crash Test Dude was created on 2001-11-05.
Who sings Once there was this girl who got into an accident?
Crash test Dummies
What are the release dates for Sports Crash - 2010 Special Edition Crash Test?
Sports Crash - 2010 Special Edition Crash Test was released on: USA: 10 April 2011
When was The Best of Crash Test Dummies created?
The Best of Crash Test Dummies was created on 2007-10-01.
How do you test air bag sensor on gmc sierra 2500?
Crash the vehicle but make sure your seatbelt is on. If airbag deploys, then the sensors were good. Replace all components and repeat.
When was the Crash Test Dummies made?
The first crash Test Dummy was made in 1995 by Mohammad Yahya Kattan in america.
How do you change the crank position sensor on 1999 Tahoe with 5.7 liter engine?
To change the crankshaft position sensor of the 1999 Tahoe, you must first disconnect the negative battery ground cable to avoid accidents. Then, remove the wire harness from the sensor, disconnect the wires, and pry out the bolt. Place the new sensor in the same area, replace the bolts, and reconnect the wires. Test the sensor to see if it is working.
