Want this question answered?
Test Drive - 2002 Jeep Wrangler Unlimited was released on: USA: 28 September 2006
Most likely, you have low refrigerant. It could also possibly be problems with your low pressure sensor. More specific troubleshooting would require a system performance test with a manifold gauge set.
You can test the 2002 Chrysler 300 M knock sensor with a diagnostic tester. The diagnostic tester will tell you if the knock sensor is working.
If you are missing the lower speeds but still have high speed, the resistor is bad.
The first step is finding what the issue is. Check the fuse to the motor. If you have access to a volt meter or test light, check to make sure that the motor is getting power when the switch is on. If power is there then the motor needs to be replaced.
Mine failed because I had a bad battery connection and my car had died the night before. I had to drive it for another 70 miles before it passed.
how to test crank sensor
To test an abs sensor for a Lexus ES you will need to use a multimeter. The multimeter will determine if the abs sensor works or not.
Test Australia The National IQ Test 2002 - 2002 TV is rated/received certificates of: Australia:G
Probably not as the emissions test (Smog test) is carried out by inserting a sensor into the exhaust pipe.
To test a crankshaft position sensor on a 1996 Jimmy Blazer, use a CKP sensor to test for voltage output. Compare the results to manufacturer specifications.
You can test the engine coolant sensor by using an ohmmeter. Attach the positive and negative probes to the terminals of the coolant sensor.