you gotta ask curtis
how do test a variable resistor
The final stage of mitosis of an animal cell is telophase. I learned this in a science test so i'm positive its the answer.
its easier to undo the motor and test that if that isn't working then it will more than likely be the resistor
To test the blower motor resistor, unplug the resistor connector. Each blower motor switch input terminal on the resistor must have continuity to the resistor output terminal, which is connected to the circuit going to the blower motor. If the blower motor resistor continuity does not check OK, replace the faulty resistor.You need a multimeter to test the resistor block and there should be continuity between all terminals.
ohm the resister with a multimeter
The Final Test was created in 1953.
If you are missing the lower speeds but still have high speed, the resistor is bad.
The duration of The Final Test is 1.5 hours.
Remove and test with an ohmmeter Explain how to test with an ohmmeter?
test stage 1
Resistor is behind glove box (Push inward on glove box hinges to release) Pull out both sets of wires from resistor plug-in. (push release clips on both sets to pull out wires) Remove 2 small screws holding the resistor. Remove the resistor ( test the wire that has the small diode ) with a multimeter to ensure it has power on both sides of the diode. If there is current on your multmeter the resistor is okay...... if no current is present on your multimeter the diode is burnt and the resistor unit needs replacement.
The Final Test - 1914 was released on: USA: 25 September 1914