It you are talking about the lower bolts then you need to remove the drive belt and the top compressor bolts and slightly move the compressor to the side and then tighten up the lower bolts and remember that you do not need to discharge the a/c system................
The 2004 Toyota Tacoma air conditioner compressor can be found on top of the engine. The air conditioner compressor will be on the left-hand side of the engine, near the front.
The 1998 Buick Riviera air conditioner compressor is located in the engine compartment. The air conditioner compressor will be on the left-hand side of the engine.
No. It should not.
On a 1996 Ford Explorer : The air conditioner compressor is on the drivers side of the engine , it's at the front of the engine and isone of the accessories that is driven by the serpentine belt
I'm assuming you mean the air conditioner compressor. Even if you have front and rear air conditioning in your van, you still have only one compressor. If you can tell us the size engine you have it would narrow the answer down a lot.
Maybe a 4 cylinder and just reacting to the additional engine power draw of the air conditioner compressor noticable as compressor cycles on and off
Evaporator drain hose routes water from the bottom of the air conditioner compressor to the bottom of the engine compartment. The drain tube will be on the bottom of the air conditioner compressor.
It is just below the ac compressor.
Any air-conditioner compressor, from a 4.3 liter Chevy engine, will interchange with an air conditioner compressor from a 1997 Chevy S 10. The air conditioner compressors are identical.
Yes as long they were mounted on the same side of the engine.
The air conditioner compressor has two fittings. You can add refrigerant to the low port fitting. The air conditioner compressor can be found on the right hand side of the engine near the front.
With an auto air conditioner, the main power consumption is by the compressor. The compressor is driven mechanically by the engine, not the battery. Electrical power is used for controls, and to power the blower fan.