Loosen the top two bolts on the Power Steering pump. then loosen the bolt in the center of the idler pulley (below power steering pump) looking at the engine from the front of car, locate the tensioning bolt at the lower left side of the power steering pump bracket.Turn this bolt clockwise to tighten belt until you get 1/4 to 1/2 inch deflection when belt is pushed in between pulleys. Tighten all bolts that you loosened.
try tightening the tension pully works like a charm
If it has a serpentine belt should be done by tensioner unless it is defective
Should have an automatic belt tensioner -perhaps it is defective I don't think there is a belt tensioner. Belt tension is adjusted at the power steering pump bracket and idler pulley assembly.
How do you tighten the serpentine belt on an oldsmobile ciera
The belt is self adjusted by way of a tensioner.
There is a spring loaded tensioner that is supposed to keep the serpentine tight. If it is loose, it needs to be replaced.
You don't tighten a serpentine belt. The tension is controlled by a tensioner. If it is loose, then the belt has stretched and needs replacing.
Put the serpentine belt around the pulleys on your 2001 Chrysler LHS. Tighten the serpentine belt by pushing the tensioner pulley to the left. Tighten down the tensioner pulley and the serpentine belt will be tight.
Most serpentine belt systems have a self adjusting tensioner.
How do you replace the serpentine belt in 1997 sunfire
A serpentine belt has an idler pulley on is to keep it tight at all times. If your serpentine belt is loose, then something is worn out. Its possible the idler pulley is stuck in its bracket so it cannot move or the spring on it is worn out.
You do not tighten a serpentine belt. It has a tensioner that keeps it at the correct tension. If it is loose, either the belt is worn and needs replacing or the tensioner is defective.
Loosen up the power steering pump and pull on pump till belt is tight.
Loosen bolt in tension pulley, then loosen tension bolt. Replace belt. Tighten tension bolt. Last, tighten bolt through pulley.
Tension is accomplished with a belt tensioner, it is probably defective and needs replaced.
You can tighten the serpentine belt on your 2005 Chrysler 300 by tightening the tensioner pulley. Push the tensioner pulley to the right until the serpentine belt is tight.
Powe stering belt (aka serpentine belt) is tightened with a belt tensioner. A new tensioner is needed if the belt is loose or a new belt
the Serpentine Belt on the 91 Lebaron is on Tension Pulley, you dont tighten it. But if it is loose and you need to tighten it you just go and buy a new belt and put that on.
Serpentine belt? You may have to remove to tighten alternator
Loosen the tensioner pulley. The serpentine belt will become loose and can be removed. Put the new serpentine belt on and tighten the tensioner pulley.
Put the serpentine belt on to the pulleys of your 1994 Chevy engine. Tighten a serpentine belt with the tensioner pulley.
usually serpentine belts get their tension(tightness) from the belt tensioner
picturediagram of how to install 89 Cherokee serpentine belt
You cannot adjust the tension on this, it has a spring inside of it. If it is weak, it must be replaced.