answersLogoWhite

0


Best Answer

In the hub assembly there is an adjusted that is threaded you just simply tighten it and align your set screws accordingly and ya da

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you tighten front wheel bearings on 2001 Honda Passport?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Change front wheel bearings on Honda ATV?

how do you change front wheel bearing for 420 rancher


Do the front wheel bearings on a 1991 Honda Accord have to be pressed out?

yes they do. I have a 1991 Honda civic and I needed to press them in and I believe they have the same front end.


Where are Honda Passport freeze plugs?

The freeze plugs on a Honda Passport are located along the front of the engine block. They allow for expansion in the event the coolant freezes to prevent cracking.


What is the wheel bearing torque specs in ftlbs on a rear wheel bearing for a 1998 Honda Accord?

what is the torque on front wheel bearings for 1998 honda accord


How do you tighten front bearing on 05 Rodeo?

Need to know which bearing and which Rodeo. There is a Isuzu Rodeo and a Holden Rodeo. Each has several bearings.


What are the replacement speakers for 1999 Honda Passport?

Front 5.25 (5&1/4) Rear 4


Where is the power steering fluid reservoir located on a 1998 Honda Passport?

The power steering fluid reservoir on a 1998 Honda Passport is found on the driver side of the engine bay. It is located in front of the brake master cylinder reservoir.


What would cause a transmission fluid leak in a 2002 Honda passport?

AnswerIt could be your boot or seal around the transmission.My 2002 passport was leaking from the front pan, the transmission has a front and rear pan and the gasket had to be replaced.


Where is the water pump located on a 1997 Honda Passport?

The pump is set into the front of the engine block. You have to remove the timing belt to get to it.


What causes a rattling sound in the front wheels of your 1995 Honda Civic after accelerating?

The rattling sound in the front of a 1995 Honda Civic wheels can be caused by wheel bearings. These bearing allow the wheel to turn and when they fail the produce a loud noise.


What if your 1996 passport is making a low pitched clicking sound?

if it clicks only when turning check to see if front axles are bad, if it clicks all the time check bearings


How do you replace the front hub bearings on a 1993 Honda Accord LX?

If you need to ask on here, then you shouldn't be doing it yourself. Take your car to a garage.