Want this question answered?
Take off the centre section of the exhaust and the heat shield and behind them you will see the handbrake cable, were the cable goes from two into one there is an adjustment nut to tighten it. Think its 13MM. turn it towards the front of the car to tighten the handbrake. If you have rear drum brakes you could also adjust the handbrake by pushing the shoes out a few clicks but that involves opening the drums and is more complicated.
If it has rear drum brakes, it's under the car, where the handbrake cable emerges from inside the car. If it has rear disk brakes, there is addition adjustment inside the rear disks on the handbrake shoe mechanism. This adjustment should be carried out before attempting to adjust the cable.
how do i adjust the handbrake of a hyudai elantra 1998 model
You need to adjust the Vernier knob on the choke. It is located behind the choke knob. It is a knurled ring that you tighten up to tighten the shaft friction on the choke cable
go to a garage they will stress for you all you have to do is pay them? lol these are a propper t**t believe me i fitted one ended up needing two cables because you find the other one is f****d also my mate owns a garage so i got help when fitting mine. you can do them yourself but you need the car up a height just to get to middle of the axel where they join.
The air filter on a 1998 Vauxhall Corsa engine is located in the engine bay. It is located at the rear of the compartment.
I dont belive you can; it may have stretched, so I would suggest you replace it before it breaks and locks your hood down.
a bod driver
The hand brake is adjusted under the vehicle, just in front of the rearend. It's a cable that splits into a "Y"; you will be able to see the nut you need to tighten. But be warned that these nuts are usually rusted up real good, so it's a good idea to spray the nut and threaded rod for several days before trying to attempt to make any adjustments. If the threaded rod breaks or the nut stripps out then you have to "replace" the entire hand brake cable assembly.
in fuel tank
I have replaced the the clutch cable on my '95 200sx 1.6L and it was easy. To adjust the cable go to the end of the cable where it conects to the level looking clutch arm in the engine compartment and look at where the clutch cable connects to the lever. Securing the cable on the backside of the lever there is a washer and screw that you can tighten or loosen to engage the clutch without pushing it all the way to the floor or you can adjust the other way to get the opposite affect. After I installed my clutch cable I had to go back about a week later and adjust the clutch (tighten the cable) because it appeared the cable had stretch a little from brand new to broken in condition. Hope this helps...
Does a 1998 Honda prelude have a clutch cable