How do you totally disable for good the factory installed alarm so it cannot keep going off ever again when you do not want it on your 1993 Jeep Grand Cherokee?

Answer 1

What I did on my 94 Jeep GC Limited. It came with a remote for the locks and security, but I no longer have it. On the roof of the inside of the car where the front map lights are there is a screw, once you undo that screw you can just pull the whole assembly down and there is a harness with connectors up there. Just disconnect the one near the back and the remote locks and security will no longer work.The link below has a diagram of where the alarm module is located. If you start the Jeep and let it run for 2 minutes, disconnect the alarm module, let it run for two more minutes, and then shut it off it will be completly disabled. If All Else Fails the following might work:If you no longer have a working keyless remote to disarm your alarm, you may insert your key into the tailgate keyhole to lock and unlock that door and stop the alarm from sounding. AnswerNO, the only way to turn it off is if you use the key in the DRIVERS door, not even unhooking the battery will work. Answerif you just want to turn it off, then using the key in the passenger door, unlock the passenger door. this turns it off. then to enable it, double lock the doors with power door locks, and close the door... look at the dash to see the security light flashing shows it active, and when it stops flashing it is armed. TO THE ABOVE:

I did the the keyhole lock/unlock thing and it didn't work and definatly not in the drivers door. that is what set the alarm off. I locked the doors using the interior power lock, closed the door. waited about 15 min. put the key in the drivers door turned left right left. opened the door and the alarm went off. this is a problem for my clicker doesn't work 1/2 the time and randomly turning locks is not working to well. I went to the sight listed below and am going to try this temporarily.

Answer