answersLogoWhite
Chevy Camaro

How do you troubleshoot and repair the powered rear hatch pulldown assembly on a 1988 Camaro?

575859

Top Answer
User Avatar
Wiki User
2015-07-16 18:19:53
2015-07-16 18:19:53

First you need to check for power (12 vdc) at the contact connector with a volt meter. If you don't have power, you need to trace back till you find where the 12vdc stops and fix the supply problem. If you do have 12 volts, make sure the contacts are in good shape and making proper contact when the hatch closes. If it still does not work, some camaro parts sites have GM replacement parts to rebuild the electric motor. Hope some of this info helps.

The replacement motor parts are available at www.hawksthirdgenpart.com

1

Related Questions

User Avatar

How do you remove the headlight assembly on a 2001 camaro?"

User Avatar

The 2002 Chevrolet Camaro is a gas-powered vehicle.

User Avatar

The 2011 Chevrolet Camaro is a gas-powered vehicle.

User Avatar

The 2013 Chevrolet Camaro is a gas-powered vehicle.

User Avatar

The 2012 Chevrolet Camaro is a gas-powered vehicle.

User Avatar

The 2001 Chevrolet Camaro is a gas-powered vehicle.

User Avatar

The 2010 Chevrolet Camaro is a gas-powered vehicle.

User Avatar

The 2014 Chevrolet Camaro is a gas-powered vehicle.

User Avatar

The 1995 Chevrolet Camaro headlight assembly diagram can be found in the Haynes repair manual. This book can be found at auto parts and book stores as well as your local library.

User Avatar

You will need a flywheel assembly, Clutch assembly, Through out bearing assembly, Bell housing and Clutch peddle assembly. A lot of hard work. Why just not beef up the automatic that's in it?

User Avatar

There are four ABS sensors on a 1996 Camaro. They are otherwise known as Wheel Speed Sensors (WSS), so there is one on each wheel hub assembly.

User Avatar

remove radiator assembly/ disconnect all bolts/ lift it from top

User Avatar

It was between the camaro and the mustang, I think it was the camaro. Gary Gabolich drove his jet powered car the "Blue Flame" 622.4 miles per hour at the Bonneville Salt Flats in Utah in the 1960s.

User Avatar

No. The headlights on a 1994 are individual and bought as an entire assembly. 1998 had a slight body restyling with the bubble headlights, requiring only bulbs to be changed instead of the entire unit.

User Avatar

remove wheel. remove brake caliper assembly(not the brake hose) and pull off the rotor.

User Avatar

You might want to purchase the factory assembly instruction manual or AIM. That has been a huge help to us.

User Avatar

find a posi out of a z28 and swap the whole axle assembly

User Avatar

I've found the same problem with my Montana, there was a crack in the assembly or cover of the the assembly allowing water to get in and make contact with the bulb....

User Avatar

remove interior panel and unscrew large black plastic nuts, remove light assembly

User Avatar

there is one 10mm bolt that needs taken out toward the top, then it slides away from the center of tha car.

User Avatar

raise the trunk. pull back the carpeting. remove the 5 plastic wingnuts holding the light assembly in. separate the light assembly from the car. twist and remove the bulb. installation is reverse.

User Avatar

pry out the switch assembly plate, disconnect the electrical connectors, then pry the window button out of the plate.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.