0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What causes minimal water flow from a shower?
Usually clogged shower heads. Turn water off and shower off. Screw shower nozzle off by hand or with pipe wrench. Turn water and shower on with nozzle head off if water flows clean or replace nozzle. If water pressure is still too low with nozzle off check shut off valve and open valve more. Make sure main water shut off for your house is open enough to allow adequate water pressure.
Why can you only get 3 or 4 gals of gas in tank before nozzle trips?
Generally this happens because of the amount of gas flowing from the nozzle. The nozzle "trips" due to back pressure. When the tank is full, gas pushes back on the nozzle and it shuts off. If the amount of fuel coming out of the nozzle fills up the filler tube going to your tank it also will cause back pressure and shut off the nozzle.
How do you inflate a water balloon with water?
put ballon on nozzle, turn water on
Why does gas nozzle at pump stop when gas tank is empty?
It doesn't. It stops when the tank is full. Assuming you are asking why the gas nozzle shuts off when the tank is full, I am not an engineer but I would guess that there is some type of pressure sensor in the nozzle that reads back pressure coming from the neck of the vehicle fuel tank and when that pressure reaches a certain point, it shuts the nozzle off.
Do Men or women drive off with gas nozzle attached?
only you do only you do
How do you make a shaving cream can shoot farther?
Pop the plastic push button off the top of the can. Replace it with a nozzle type of button like you find on a can of hair spray. Or use the nozzle and straw off a can of WD-40. It may leak around the nozzle, but it's only shaving cream! You should be able to get 5 or so feet out of it.
WHAT IS SR Nozzle?
SR nozzle means "Self Reinforced Nozzle".
What is the most affective way to get propane to last?
You need to make sure that the tank is installed properly and all wires and clasps are not split or old . Always make sure you turn it off right after using it and tighten the nozzle.
How do you replace the blower motor resistor in a 2001 villager?
To replace a blower motor on the resistor first you take off the nozzle and then you go into the motor through the nozzle and unlock it then repeat and oil and done.
What is the nozzle coefficient of a bit nozzle?
0.42
What is convergent divergent nozzle?
Convergent nozzle indicates nozzles will converge with an end closing together at the end divergent nozzles increase size at the end. If air flows in this direction: ---> Convergent nozzle > Divergent nozzle <
How do shotgun chokes work?
The choke on a shotgun "chokes" the end of the barrel, compressing your shot. Therefore creating a tighter pattern. Kind of like a nozzle on a hose. If you turn it on without a nozzle it will come out thick and not go very far, put a fine tipped nozzle on and the water will stay together and travel farther. Hope this helps.
