Want this question answered?
igntion off. press and hold down on the button on the dash. turn ignition on. and wait for the spanner to disappear. turn igntion off. don't be alarmed if the trip meter resets cos it will go back to normal when the spanner light is removed from the dash.
to get the spanner (or service me now) light off all you have to do is turn the ignition on while the engine is off and hold in the trip meter reset button for six seconds or so.
it means the car is ready for a service/ My vectra displays a oil can and spanner when a service is due, if you cannot afford a survive do the following: place keys in ignition but don't turn on, press the button that zeros the miles on the dash and hold it in, place foot on brake and also hold it down, turn ignition on but do not start engine, count to five and release button and pedal, turn ignition off then on again and the service light should havd gone out. When i get a spanner and car come up it says there is an electrical fault.
If you mean the orange light showing oil can and spanner hold both foot brake and throttle, turn on ignition and hold for 30 seconds. The light will flash, turn off ignition job done.
All you have to do is turn the ignition off and press and hold the left button on the dash and then turn your ignition back on there will then be displayed a symbol of a spanner and a timer starting from 10 and wait for it 2 count all the way down then turn your ignition off and job done.
punch it out
turn ignition to position 2..press brake and throttle together for 15 seconds..light will flash..release and switch off...done!
you reset your car. It should be in the trunk.
If the light says off then your overdrive is turned off, push the button again and the light will turn off and overdrive will be on again.
Shut the door!
There is a power or ground wire hooked up backwards. (95%sure)
Switch ignition OFF Press and hold in button between speedo & water temp Switch ignition ON (not start) Keep button in for 10 seconds Display will now read zero and "spanner" symbol gone Relaese button & switch ignition OFF