0
Add your answer:
Earn +20 pts
Can you turn flaps off on flight simulator?
Yes -by pressing f7
How do you turn on instant replay in Microsoft Flight Simulator X?
Pause immediately after landing, go to Alt(button) options - replay. Or you can download fs recorder
How stop an engine in Microsoft Flight Simulator X?
If you look around the cockpit should be a switch or key labeled "Magneto Switch", turn that to off to stop the engine.
How do you start an engine in Microsoft Flight Simulator X?
Normally to start is } and to turn off is { Helicopters are hard to fly though, and if you're planning on flying them often you will need a joystick.
How do you add aircraft into airports on Microsoft Flight Simulator X when your in your own aircraft?
turn up the air traffic and ground traffic in settings on fsx. Not the more you have the more cpu use the programme demands
What is a magnetic needle that is free to turn?
Compass
How do you unpause Microsoft Flight Simulator X?
The default to pause and unpause Microsoft Flight Simulator X is the "P key". If this doesn't work you were probably changing control commands in the settings and either changed it without remembering or assigned another control to the "P key", which in turn, unassigned the pause control. To reassign the pause key go to controls in settings, double click the control you want to reassign and then press the key(s) that you want to use for that control.
In a compass why must the friction be low?
The friction in a compass must be low so that the compass needle can turn freely and point to magnetic north.
What is a small magnet that can turn freely and always point north?
A compass.A compass.A compass.A compass.
How can you get into the vent in the golden compass ds?
You turn Pan into a moth and fly into it
Does a compass turn near a closed circuit wire?
It will if there is current flow
How do you turn on 3-D buildings on Google earth flight simulator?
Image processing is used. I cant explain the whole thing in detail as it is complicated, there are several method available using which two dimensional images are converted to 3d models the most difficult is to generate a 3d model from a single image as every image has a depth information in it and depends in the way the image was captured, other methods are to use multiple images, etc.....
