Turn the ignition on, with the engine off. Press the gas pedal to the floor three times in ten seconds.
Mine too, I went to the dealer. They told me it's normal, the new design, but I doubt.
Turn the key on with the engine off. Press the gas pedal down three times in ten seconds.
First, make sure you get an oil change at a local Jeep dealership. Then turn the ignition key to the on position, but don't start the car. Slowly tap the accelerator button a few times within ten seconds. Then turn the ignition off. The car should work just fine after that.
Turn the ignition on, with the engine off. Press the gas pedal to the floor three times in ten seconds.
1. Turn the ignition switch to the ON position. Do notstart the engine.2. Fully depress the accelerator pedal, slowly, three timeswithin 10 seconds.3. Turn the ignition switch to the OFF/LOCK position.NOTE:If the indicator message illuminates when youstart the vehicle, the oil change indicator system did notreset. If necessary repeat this procedure.---Good luck on resetting the change oil light.
According to the manual, there is no switch. It's push to turn on/off. Mine doesn't work though, and doesn't push in.
Patriotism is the abstract noun form.
Clockwise.
this is nice
What date do you legally have to turn heat on in NJ?
how do you replace a turn signal bulb on a 2004 jeep liberty. I can not find screws or a panel to go through