First off, we don't know what kind of car you have and second, not knowing what you are doing could cause yourself bodily harm or worse.
loose wire somewhere from ignition switch to starter.
easiest wat to check a starter is to turn on ignition.then with a screw driver cross the positive lead to starter wire on the starter motor if the starter is good this will turn over the engine if starter is bad it will not if this does tuen over engine , you can then check solenoid and other ignition parts
Drive a flat blade screw driver into it. Then turn screw driver to on position.
lmfao. why do you need to do that? you need to take apart the whole steering column. Take off the case, take off the starter, separate the starter with the thing on the back of the starter. Take the part you separated and put a screw driver inside of it and turn.
Most likely. Same thing happend to my ZX7R, if I have the starter button pushed in and hit the relay with the back of a screw driver I can get the bike to start.
There is an idle screw on the side of the carb its the one you can turn by hand if you have to use a screw driver its probably not the idle screw. turn it CW to increase and ccw to decrease.
its probbaly the starter. i have a 1993 and mine went bad. check all the wires and tighten everything that's loose and if that dosent work put a screw driver across the terminals on the starter and if it dosent turn over then the starter is bad
Replace starter solenoid? Could be a bad neutral safety switch
It could be any of a few things: starter keyswitch neutral safety switch poor connection DEAD battery (but it would need to be really dead to not even click) try starting it with a screw driver on the starter
Yes, if you remove the dome light you should be able to turn the motor with a screw driver.Yes, if you remove the dome light you should be able to turn the motor with a screw driver.
Get the battery from the toy car using the screw driver. Put it in the TV remote and jump on the green button (the biggest one).
changed seliniod on starter and on firewall ,checked fuses still won't turn over, if I cross the upper seliniod with a screw driver it turns over but won't start?