To turn the lever you can use a 1/4" drive ratchet, a 4-6" extension bar, and a 5mm socket. Alternately you could use a nutdriver with the same 5mm socket as long as the shaft is long enough to provide clearance for your hand. Turn the lever counter-clockwise 180 degrees to free the headlight housing. Use a long screwdriver, about 12" shaft, or a similarly long stick or other object to push down on the aluminum catch located behind the headlight housing. This catch can be seen by looking in the void immediately behind the battery box at the back of the headlight housing. It is a rectangular catch that will easily release when you press down. The headlight housing will then slide out of the front of the car by pushing from inside the engine compartment. Do not let it slide out and hit the ground. Slide it slightly forward and then stand in front and pull it the rest of the way out. Tools needed: 1/4" drive ratchet 6" or longer extension bar for the 1/4" drive ratchet 5 mm socket 12" or longer screwdriver, stick, or similar object alternately: 5 mm nutdriver with 6-8" shaft
The headlight on your 2008 Hyundai can be removed by removing the headlight retaining bolts from the inside of the engine compartment. Remove the wiring harness and replace with a new headlight.
Page 405 in your owner's manual.
Pull the complete headlight assembly out to get to the bulbs. You first have to pull the front bumper off, along with the wheel well to get to the headlight assembly.
See "Headlight" on page 52 of chapter 11 "Maintenance and Service" in your "OWNER'S MANUAL".....
Open your hood and remove the 2 push pins that connect the engine compartment plastic separator. There are also 2 bolts to remove and then you can pull the headlight from the frame. Replace the bulb and put the headlight back.
where is the oil filter on a 2008 vw beetle
There is lots of space to replace the headlight just unscrew the bolts i think its 2 of them and there is a plastic clip that usually holds them in.
Remove tire & inner liner to gain access to head light assembly
Remove the knobs, remove the dash panel, and replace the switch.
Open the hood. On top of the headlight assemblies, there's a curved metal rod. Pull that out, and you can pull the headlight assembly right out. From there, you turn the bulb ballasts counterclockwise and pull them out, and you can either replace the bulbs at that point, or the whole headlight assembly if necessary.
My daughter has a 2002, and you must take it to the dealer, so we were told.
Not an easy task since you have to remove the Front Bumper Cover to get access to it. Once that's done, remove the electrical connectors, the screws and the Headlight Assembly.