Put the car in drive, unbuckle, and floor the gas pedal. The lights will turn on as needed.
With the lights on pull on the turn signal lever. High beams should come on. Pull again and they should go off.
I have 90 cutlass supreme. look under center of car for gas tank. should be on back end of the tank. need to jack up high enough to get at.
it the handle on the side of steering wheel chick it towards you or oppsite
SAE 10w30 any major brand high mileage oil.
Check to see if the throttle plate is stuck
Pull the turn signal lever towards you until it clicks, then let it go.
Bad bulbs Bad dimmer switch
your bulbs are burnt out. when you switch on the high beams its only the high beams. but when you flash your brights it lights up both high and low beams.
Low retail, $1,725. Average retail, $4,100. High retail, $6,400. It's all about condition.
low pressure side is the line which runs from the condensor to the compressor.low pressure goes in , high comes out.high side is line going to the cooler mounted on the front of the radiator
yes, but i think more off bright lights not high lights
Assuming that one side is still working, turn on your lights in low beam, get out of car and look. Then turn on the high beams and look again. See sources and related links below for bulb info.