0
What else can I help you with?
Which way do you turn nut on oil pan to loosen?
To loosen a nut on an oil pan, you generally turn it counterclockwise (to the left). This is the standard direction for loosening most nuts and bolts. Always ensure to use the correct size wrench or socket to avoid stripping the nut. If the nut is particularly tight or rusted, applying penetrating oil may help ease the process.
Where is the oil drain plug in a 1994 ford explorer?
Underneath the engine on the oil pan. Large nut.
Where do you put oil in 2006 suzuki forenza?
To flush the oil, you need to open a the nut which is located right under the engine...its a a little big nut with a metal washer. And when your done close the nut but not too hard because you can strip the threads....then you put the oil from the oil cap which is on top of the engine... Don't forget to change the filter too!! its probably black or white the color of it..
How do you change BMW r850r engine oil?
Set bike on the center stand. Run engine two minutes, unless already warm, to loosen up oil. Remove nut from engine (bottom left), open oil filler cap (left engine cylinder). Drain out oil. Remove oil filter. Replace with new filter. Replace nut, prefereably with new washer. Fill up oil reservoir with recommended quantity of oil. Replace oil filler cap.
How do you turn off the Oil light on my 1993 civic will not turn off?
increase engine oil by adding more oil
Can a Hemi turn the check engine light on for the wrong oil?
Yes, it can turn the light on for the wrong oil.
How do you install a governor on a 5hp Briggs and stratton engine?
You loosen the nut own the governor arm turn the arm clockwise and then turn the governor shaft clock wise. Tighten nut That should do it.
How to get oil out of engine cylinder?
take the spark plugs out then turn the engine on
How do you replace the water pump on jeep 5.2 engine is the nut that holds the fan clutch on right or left hand thread?
As you face the engine, you need to turn the nut in a counter-clockwise direction.
How hot would engine have to get to turn oil to ash?
The engine will seize and lock up way before it gets hot enough to turn oil to ash.
Set tappits with engine running on 396 Chevy engine?
Remove valve covers. Install some oil splash shields on the rocker arms. With the engine running back off the rocker arm nut until you hear it start clicking. Slowly tighten the nut just until the clicking stops. Now turn 1/2 to 3/4 of a turn. Do that to all 16. That's it. This is provided you are running a hydraulic cam and lifters.
Where is oil drain plug on Kawasaki JX 75 engine?
There is no drain plug as you might expect with a car's oil pan. The oil is drained by attaching a plastic tube (comes with mower at time of purchase) to a connector at the bottom side of the engine, above the mower deck. Turn the nut to loosen the connector attach the tube and continue to turn the nut. Tilt the mower deck by raising the opposite side of the mower deck and the old oil will flow through the tube. Once dry manually tighten the connector, remove the tube and then use a wrench to snuggle tighten the connector.
