answersLogoWhite

0


Best Answer

It needs to have a separate switch for the front and rear lights.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you turn your back lights of your 1990 Acura Integra off?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you replace the left rear brake light bulb on a 1998 Acura Integra hatchback?

On a 1989 Acura Integra hatch back the brake lights are reached through the hatch itself. The brake lights housing are on the rear of the vehicle. Unplug the bulbs and replace them.


How do you remove the back seats from a 1994 Acura Integra gsr?

The back seats on a 1994 Acura Integra are mounted on bracket that attach to the body of the vehicle. Push the back of the seat down and loosen all the bracket bolts. Pull the seats out.


Where is the themostat on the 1996 Acura Integra locate?

If yoor 1996 Integra has the1.8L engine, the thermostat is located at the back of the motor at the end of the bottom radiator hose.


Where is the fuel pump relay at on a 1990 integra?

I believe it is underneath the back seat.


Where exactly is the fuel pump relay located at on a 1990 Acura Integra?

It is going to be in 1 of 3 places. Under the hood in the fuse/relay box, under the dash near the steering wheel, or under the back seat.


Where is the computer located on a 1990 Acura Integra 4-door ls?

Underneath the passengers seat Actually its on the passenger side but on the front of the floor board. Just peel back the carpet on the front passenger side and you will see it


When upper radiator hose on 1993 acura integra is removed there is no thermostat any ideas?

theromstat housing on the back not the front


What are the steps for replacing a fuel pump on an 1990 acura integra after removing the back seats and the three screws on its cover?

im not sure but on the 90 acura integra, the fuel pump is beside the gas tank on the driver side, that is the fuel level sending unit The pump is in the tank. undo the nuts on the top and pull the top up. connected to it is the pump itself. pull the connecter and hose off and replace. then replace the strainer and put back together


How do you get your 1990 acura Integra ch eck engine light off?

disconnect your negative battery terminal for about 10 minute then reconnect it. If it comes back on you my need a repair shop to reset it or check to see what is making the light come on


How do you replace a speedometer cable on a 1990 acura integra?

Start by removing the gauge cluster, unhook the speedometer cable from back of cluster. Pull speedo cable thru the firewall, follow it down to the transmission, and then unhook it. Install in reverse order of removal.


Where is the started located on an Acura integra?

The starter is located on the back of the engine, near the bottom. You can follow the positive cable from the battery directly to the starter.


Where is a wire diagram for a 2000 Acura Integra?

I found this site, http://installdr.com/InstallDocs/Acura/Integra.html, hope it helps.