0
How do you turn your oil pump down on your peugeot speedfight 2?
Wiki User
∙ 10y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you bypass the imobliser on Peugeot speedfight 2?
Either use the key given with the bike to turn the immobilizer off. (If you don' have it) Get a new CDI.
Peugeot 205 will not turn off?
If its a Diesel, its probably the Diesel Stop switch. Located on the Diesel Fuel Pump.
Where is petrol pump located on Peugeot 106 xn?
hi can any one help me as i have a peugeot 106 quicksilver 1.4 my fuel pump has stop working it just wont pump the fuel up but when u turn the car over and u stop turning it over u can here the fuel pump work but it just dont work it does not come on when u just turn the ignition on as it should do any idea thanks simmors2009@live.com
Where do you find the fuel cut off valve on a Peugeot 307 Hdi?
Its all electronics. Either turn your fuel pump off manually by cutting power supply. In practice, when you turn switch off, hdi pump and injectors stop as well. There is no mechanical valve.
If the button is hit in the trunk to turn the pump off how do you turn it back on you do not have a manual?
push the button down.
Turn off service indicator on Peugeot 407?
Hold in the oddometer reset stalk then turn the key into the on position, without starting. Then watch it count down to zero on the display and reset to 20k
Peugeot 406 HDI starting problems Prob - turn over engine for about 30 secs before it will start. then car runs normally any suggestions?
Weak fuel pump Bad injectors
How do you turn service light out on peugeot 307?
Service your car.
How do you turn the Peugeot alarm on and off?
Press the "off" button.
How to change cambelt on Peugeot expert?
Correctly locate the timing pin and then ensure that the camshaft sprocket is locked with the bolt. The camshaft sprocket bolts are then slacken and then you fully turn the camshaft sprocket clockwise in the slotted holes. Slacken the bolts in the injection pump and you fully turn the injection pump sprocket clockwise without resistance. Finally you fit the belt in the crankshaft sprocket.
What could be wrong if you are checking for blockage in the lines and pour garden hose water down the pump inlet and water runs down fine but when you try to prime the pump you still get no results?
Check to make sure the basket part of your pump is full of water. If it is an above ground pool an easy way to fill the pump basket and prime the pump is to turn off the pump and set the filter valve to "backwash". Turn pump on and run until water in sightglass runs clear. The pump should have achived primed now. Turn pump off and reset valve to "filter", turn pump on. I do not take off the pump basket lid because the water will come out of it very fast and it is very difficult to replace the lid with all that water gushing up(unless you have shutoff valves or plugs for the lines. I do not have them).
How do you turn off the service spanner on a peugeot 207?
smash the clocks out with a hammer
