0
trun off the cit and remove fan pull . look for the closest plug to left or right or just below it open them up and use a tester to find the wire going to the fan trun the power back on check that all is working if so trunpower back off and put wire nut and label on wire in box and push into wall with wire nuts and tape it all together and put plug back and trun power back on
What else can I help you with?
How do you wire a 1999 Yamaha blaster ignition?
You unhook the two wires that lead from the ignition to the electrical.
Can you swap wires for light and exhaust fan switches?
It is not recommended to swap wires for light and exhaust fan switches without proper knowledge of electrical work. It is best to consult a licensed electrician to ensure the correct connections are made for both safety and functionality.
How can I hardwire a dishwasher into my kitchen's electrical system?
To hardwire a dishwasher into your kitchen's electrical system, you will need to first turn off the power at the circuit breaker. Then, remove the electrical cover plate on the dishwasher and connect the wires from the dishwasher to the corresponding wires in the electrical box using wire nuts. Finally, secure the connections with electrical tape, replace the cover plate, and turn the power back on at the circuit breaker. It is recommended to consult a professional electrician for assistance to ensure safety and compliance with local building codes.
Can you splice wires in an electrical panel?
yes wires is electrical panel
How do you unhook a factory alarm system on a 1998 Eddie Bauer edition Expedition?
To unhook a factory alarm system look for the alarm brain on the dash and Cut the two red and blue wires. Reconnect the wires and the alarm will be reset it self.
What is the use of electrical?
To strip electrical wires and to twist mutliple wires together.
How do you change a headlight to a 94 Lincoln mark 8?
unhook the wires then undo the clips easy as that!!
How do you install an O2 sensor on a 2004 Chevy Trailblazer?
There are multiple sensors on the vehicle. All are on the exhaust and are accessible from underneath the vehicle. They connect with a snap connector on the electrical wires, and the sensor itself is screwed into a half coupling that is welded onto the exhaust pipe.
What are the necessary steps for properly wiring a range hood in a kitchen?
To properly wire a range hood in a kitchen, follow these steps: Turn off power to the kitchen circuit at the breaker box. Install a dedicated circuit for the range hood. Connect the wires from the range hood to the corresponding wires in the electrical box. Secure the connections with wire nuts and electrical tape. Mount the range hood and secure it in place. Turn the power back on and test the range hood to ensure it is working properly.
How should I properly install and wire an electric stove in my kitchen?
To properly install and wire an electric stove in your kitchen, follow these steps: Turn off the power to the kitchen at the circuit breaker. Remove the old stove and disconnect the existing wiring. Install a new dedicated circuit for the stove, following local electrical codes. Connect the wires from the stove to the corresponding terminals on the electrical outlet. Secure the wires with wire nuts and electrical tape. Turn the power back on and test the stove to ensure it is working properly. It is recommended to hire a licensed electrician for this task to ensure safety and compliance with regulations.
How can I remove an Insinkerator from my kitchen sink?
To remove an Insinkerator from your kitchen sink, first turn off the power to the unit. Then, disconnect the unit from the sink by loosening the mounting screws and disconnecting the electrical wires. Finally, remove the unit from the sink by lifting it out carefully.
How does electrical energy travel?
Through electrical wires.
