If you are having a problem with the alarm going off seemingly at random or will not disable even with the key in the lock or ignition. the problem is your battery. I have had this problem, when the security system is acting odd..get the battery checked right away, you may have to have a dealer re-program your computer also. you cannot disconect the alarm.it works with a frecuincy receiver in the pasengerdoor on the door lockswitch You can ground out factory alarm by removing driver side kick panel, finding purple wire with yellow stripe. Expose portion of wire...do not splice in half. Take piece of speaker wire, connect one end to exposed portion of purple & yellow wire, and ground other end of speaker wire to metal part of Jeep. This will disable alarm. Just did mine 2 days ago.
the aftermarket alarm kit
To unhook a factory alarm system look for the alarm brain on the dash and Cut the two red and blue wires. Reconnect the wires and the alarm will be reset it self.
it could be the factory alarm system
It is an integral part of the computer system and can not be removed.It is an integral part of the computer system and can not be removed.
how to disable alarm on 1998 jeep grand cherokee
The alarm system on your Jeep Grand Cherokee is controlled by a small, approximately 3 inch square box that plugs into wiring under your dash on probably the drives side towards the middle. It is black in color and is printed with the words "alarm module. If you unplug that the alarm system will be permanently disabled and starting issues may be resolved as well.
i need to disable jeep factory alarm 1997 cherokee
Insert the key in the drivers door and unlock, lock. unlock again. That is how a factory alarm system is bypassed in case your battery dies in your remote.
go to www.commandocaralarms.com/wiring/1996/Jeep/Grand-Cherokee and it will have a chart of wires and wire location. i have a 1996 there all the same.
The factory alarm is built into the Body Computer. It is not possible to unhook it.
How do you disarm the security lock on a 1995 Jeep Grand Cherokee Laredo?
How do I disarm the security on 1995 Jeep Grand Cherokee?
The factory alarm can not be disabled, only repaired if malfunctioning.
The factory alarm system can not be disabled or bypassed. Any failure would need repaired.
Most of them do have the Sentry Key system (chip key). An alarm was an option.
turning key in the door lock should disengage the alarm
No such part.
If the alarm is factory... Take the key and put it in the drivers door.. turn the key to lock position then to the unlock position. The alarm with reset
The factory alarm is reset by unlocking the doors with a key or remote.
The factory alarm can not be disabled. The alarm is a function of the engine, body, and key computers. The alarm is reset by unlocking the doors with a key or remote. If malfunctioning a scan tool is required to diagnose.
You can not. The "alarm" is an integral part of at least three computers on the Jeep. The pcm (engine), bcm (body functions), and the skim (chip key system).
Unhook your positive battery terminal for 5 minutes. Then use key in passenger side door (after you reconnect battery) turn left/right 2 times this should reset your factory settings.