How do you change the battery in mazda 5 key?
967430
Hold the fn key down for 5-10 seconds
u need to masturbate 5 times to get the key . .seriously
Sounds like you've got a key with a chip in it. Must be programmed and copied at a Mazda dealer. Not cheap, either.
Take all keys to dealership service dept.
The new device can be purchased online for about $5 and sends an electromagnetic pulse through a car's key area to unlock the vehicle.
This is how to program a Mazda protege keyless (also works with other Mazda models) remote system: 1. Open Drivers door and leave open. 2. Lock and unlock the drivers door using the power lock switch on door panel. (not sure if this is required) 3. Insert key into the ignition. 4. Turn key to the ON and OFF position 3 times in 10 seconds. Leave key in ignition. ( i have seen others say 24 seconds for 4 & 5 combined) 5. Open and close drivers door 3 times ending with door in the open position. (you can depress the door switch instead) 6. Door locks should respond by locking and unlocking. 7. Press any button on remote 2 times. Doors should lock and unlock. 8. If programming a second remote press any button 2 times on it and door locks should cycle again. 9. Remove key from ignition and door locks will cycle again. 10. Test remotes. This information was received from: How do you program a keyless entry remote for your Mazda 5
I Just reach lv 5
mazda premacy is the same as mazda 5 , so will fit to mazda 3,mazda 5, mazda 6 ,etc etc 5 lug 4,5 inch or 5x 114,3 mm. high posite offste.
On my 99 you have to put the key in the ignition and turn to accessory... then press the trunk unlock button
On my 99 you have to put the key in the ignition and turn to accessory... then press the trunk unlock button