answersLogoWhite

0

How do you unplug a Camry power cable?

Updated: 8/16/2019
User Avatar

Wiki User

15y ago

Best Answer

You have to disconnect the negative cable from the battery.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you unplug a Camry power cable?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

When connecting a floppy disk drive cable to a signal cable to the floppy disk drive what precaution should be taken?

Unplug the power cord


Speedometer cable in a 2004 Camry?

The speedometer cable for a 2004 Camry?æranges in price close to $40 each. The cable should be installed by a professional.?æ


Trunk stuck shut in a 1998 Camry?

How difficult is it ro replace the trunk cable in a 1998 camry? The trunk is stuck shut and I was told the cable snapped. Thanks!


How do you get offline?

Unplug the ethernet cable or your wifi connection. then shutdown


How would I change out a cd drive?

disconnect all power. unplug all electrical cables from the back of the computer and press the power button. Remove the rear or side of the computer to see the inside. Locate the cd drive. Unplug the CD-ROM unit's cable from the main system board. The connection can be a thin ribbon-like cable with a bar-shaped connector that plugs into the rear of the CD-ROM unit. The cable may look like a small tube-like cable, as well. Take the power cable from the back of the CD-ROM. Use a screwdriver to remove any screws. Slide the cd- drive out and put the new one in the same place. attach the existing cables and plug the power cable in. reattach the rear or side computer panel and return the power.


Try the following st?

Try the following steps and check if it fixes the problem after each step: 1) Unplug the power from rear of printer, then press & hold the power key for at least 30 seconds, then release the key & plug in the power cable back. 2) Unplug the power cord from rear of printer. Press and hold the # and 3 keys together and while holding them plug the power cord back in. 3) Unplug the power cord from the rear of printer. Press and hold the # and 6 keys together and while holding them plug the power cord back in.


How do you unplug battery cables in a car?

Disconnect the negative cable first.


Can you unplug the video cable to your xbox while its turned on?

yeah, if you want to.


Where to find Circuit breaker for power window in 1992 Camry?

Where is the circuit breaker for power window in 1990 camry?


How do you disassemble a magic chef dryer?

Unplug its cable from the power source and remove the lint screen. Loosen the retaining clips and unplug the door switch harness. Release the screws securing the front panel and release the belt from the pulley. Disconnect the door springs.


How do I reset the ink level to full for a refilled HP 94 ink cartridge for Hp office jet 7310?

Semi-full reset: a. Unplug the power cable from printer when the printer is powered on. b. Press and hold # and 6 while plugging in the power cord. c. Wait until "Semi full reset" displays. Partial reset: a. Unplug the power cable from printer when the printer is powered on. b. Press and hold # and 3 while plugging in the power cord. c. Wait until "partial reset" displays.


How do you unplug your guitar cable from your electric guitar if it is stuck?

You can try to rotate the plug to see if it loosens a bit. If it doesn't, your best bet is unscrewing the screws that are holding the jack connector in place. You can then easily unplug the cable.