unplug the sensor attachment from right under the seat
look under the drivers seat and passenger seat and there should be a wire coming off the seat belt that you can unplug to stop the chime.
look under the seat near the seatbelt coming thru the carpet and unplug the wiring should only be 2 wires, don't unplug your electric seat if so equiped
Turn the key to the on position, do not start the car.Wait for the seat belt light to turn off (about 30-45 seconds)Plug and unplug the seat belt 3 times ending in the UN plugged position.Turn the headlights on for about a second and back off.Plug and unplug the seat belt 7 more times.The airbag light will flash multiple times, turning off the chime.Read more: How_can_you_disable_a_seat_belt_alarm_in_a_2010_Ford_crown_Victoria
The chime will continue to sound if you unplug the connection. Simply buckle up.
Turn the key to the on position, do not start the car. Wait for the seat belt light to turn off (about 30-45 seconds) Plug and unplug the seat belt 3 times ending in the UN plugged position. Turn the headlights on for about a second and back off. Plug and unplug the seat belt 7 more times. The airbag light will flash multiple times, turning off the chime.
PUT YOUR SEAT BELT ON THE LIGHT WILL GO OUT WHEN YOU WEAR IT There are instructions in the owner's manual for how to disable the nagging seat belt light. It's a convoluted sequence of plug & unplug the seat belt, do the hokie pokie, etc, something that could never be done accidentally. It may take you a couple of tries to get it right.
Yes, by buckling your seat belt. If that does not work, take it back to the dealer for repair. It is still under warranty. Just reach under the drivers seat and unplug the wiring harness plug and your noise will go away....
start with the car off and have seat belt plugged in. start the car and wait for the first alert. plug and unplug the seat belt atleast six time in the first 30 seconds ending with it plugged in. turn the car off and then back on you should be good to go.
there should be wire at the base of the seat belt that you can unplug. WHY WOULD U WANT TO REMOVE THAT DO U WANT TO DIE
UNDER THE DASH IS A BLACK LILTE BOX IS REALY CLOSE TO THE GAS PEDAL YUST UNPLUG
yes it is possible, I have done it myself already. take 2-3 screw off the panel were the seat belt runs through and just unplug the clip wire and that will take care of it for ya.