Most Toyota trucks have their antennas unscrew. So try to just unscrew the antenna at the base.
In order to recode the radio in your?æ1995 Toyota 4 Runner you will need the old radio code. You can obtain this code by contacting the Toyota company.
Responde a esta pregunta ...
The 1992 Toyota 4-Runner does not have a separate fuse for the clock. There are, however, two fuses that control the radio and clock. At slots 18 and 19 in the fuse box, there is a mirror/radio fuse and a radio fuse.
If the radio and antenna are both malfunctioning on a 1998 4 Runner their may be an issue with the wiring. Check the wire with a spark tester and see if there is any current flowing through it.
To install a manual antenna on a 1996 Toyota Camry, a hole will have to be drilled into a fender somewhere near a side mirror, if there isn't already one there. The hole should be smaller than the nut that will hold the antenna on. Thread the antenna wire in and connect to the back of the radio, then tighten down the nut to hold the antenna in place.
remove wheel and remove the plastic liner inside the fender. remove the radio and disconnect the antenna wire. Tape another, 10' long wire to the end of the antenna wire. Unscrew the nut around the antenna from on top. pull the antenna and antenna wire out through the fender. Tape the 10' long wire to the new antenna wire and pull it back through the dash to the radio.
Radio antenna can be translated as: Funkantenne Radionantenne
First, examine the factors: The radio can be switched on, but there is no sound, and the antenna does not extend or retract. One possible solution could be replacing the fuse.
Bad antenna? Radio needs to be trimmed Bad antenna? Radio needs to be trimmed
The radio antenna converts electromagnetic radiation to electrical energy
Could be broke, or might just be a Hyundai radio. Check antenna, and cable from antenna to radio.
To connect the radio antenna on a 1993 Ford F-150, the back of the radio needs to be exposed under the dash. Plug the radio antenna wire into the back of the radio and tighten the nut.